Alula RE667W Manual
Jelajahi secara online atau unduh pdf Manual untuk Panel sentuh Alula RE667W. Alula RE667W 12 halaman. Slimline touchpad
Halaman Cetak
Connect Family
The RE667 Slimline Touchpad
for controlling the security system. It is AC powered and
communicates with the panel wirelessly.
Features
• Vibrant 7'' Android™ tablet display
• Provides local control of security and automation functionality
• Wall or table mounted
• Encrypted, Connect+ and BAT-Connect enabled, battery-backed
Wi-Fi™ connection
Installation Overview for Connect+
1. Confirm the panel has a Wi-Fi DeviceLink card installed.
Installing the Wi-Fi DeviceLink Card
• Disconnect the panel's AC power and backup
battery.
• Install the Wi-Fi DeviceLink card in Slot 2 by
carefully aligning the nylon retention posts and
the 8-pin connector while pushing the card
firmly until all posts are fully seated.
• Reconnect the panel's AC power and backup
battery.
• Verify the Wi-Fi card LEDs are on.
2. Choose a mounting location. Touchpad can be mounted on a wall or tabletop.
3. Identify your network and verify signal strength before mounting it permanently.
1. Ensure the panel is powered.
2. Power the Touchpad by applying AC power.
3. Select the "Connect" option to see the available networks. If the "Connect" option is
not available, press "Setup" then "Factory Default". The Touchpad can be connected
to either the Wi-Fi DeviceLink card or the home router for internet access. (Internet
access allows camera control and the ability to modify users.)
4. Once a network is determined, verify the signal strength. If the signal strength
displayed is less than 35, relocate the Touchpad or Connect+ panel. If neither options
are available, install an RE621 Touchpad Range Extender.
Note: If connecting to a home network router, the Connect+ needs to be connected
to the same network via ethernet. The Touchpad cannot connect to the panel over an
unsecured or open network.
RE667 Slimline Touchpad
is an intuitive interface
AC Power
Input
I
Slot 2
Backup
Battery