Alumax SPEEDSTALL 794S Series Panduan Petunjuk Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Kandang Alumax SPEEDSTALL 794S Series. Alumax SPEEDSTALL 794S Series 9 halaman. Shower enclosure

Halaman Cetak

Place the two wall jambs [E] into the ends of the curb

assembly [A]. Plumb the jambs and mark the hole locations

on the wall. Masking tape may be used to hold the curb in

place during this operation. Remove all parts and drill the

walls for mounting hardware.

For tile or marble walls, drill six 3/16" diameter holes and

insert the plastic wall anchors [F]. Attachments to fiberglass

or acrylic units can be made in two ways. If a reinforcement

is built into the wall of the unit, drill six 1/8" diameter holes to

install mounting screws directly into the reinforcement. If

walls are not reinforced, drill 3/16" holes and install plastic

wall anchors or Molly bolts (Molly bolts not supplied by

LUMAX

Wipe the shower walls and sill, curb assembly [A]

and wall jambs [E] with a clean, dry cloth to remove any

dust or debris. Apply a 1/4" bead of caulk along the inside

of both of the pencil lines marked in Step #3. Carefully

replace the curb assembly in the exact position marked.

Caulk the inside of the curb ends where they meet the

wall. Caulk generously around the anchor plates [B],

screws [C], and the insides of the mitered joints.

Replace both wall jambs and attach to the walls with six

#8 x 1 1/2" truss head screws [G].

NOTE: Panels with obscure or textured glass should be

installed with the rough surface of the glass to the exterior of the

unit. Deco or etched glass panels should be installed with the

patterned surface to the interior.

Snap one of the S

PEED

TALL

next to the wall jamb [E]. Slide the panel over into the wall jamb.

Press a 135° post [J] into the curb. Slide the side panel across

until it is centered between the wall jamb and post. Use masking

tape to hold the post in position temporarily.

Repeat for the other side panel and 135° post.

NOTE: Apply several small dabs of caulk to both sides of the

panel rails (see arrows) before setting into place. This will help

prevent rattles caused by metal-to-metal contact.

side panels [H] into the curb [A]

Page 5 of 9

G03711103

8-22-06