Alumax SPEEDSTALL 794S Series Panduan Petunjuk Instalasi - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Kandang Alumax SPEEDSTALL 794S Series. Alumax SPEEDSTALL 794S Series 9 halaman. Shower enclosure

Halaman Cetak

Insert the two nylon pivot bushings [Y] into the

pivot holes in the head and curb fillers [P].

Lift the door panel [L] and insert the top pivot pin into the

pivot bushing in the header filler. Hold the door vertical

and insert the bottom pivot pin into the pivot bushing in

the curb filler. It may be necessary to remove the header

retaining screws and raise the header slightly to install the

door.

When the door has been set into place, snap the security

washer [AA] over the top pivot pin to hold the upper pivot

bushing in place and prevent accidental dislodging of the

door.

Cut the drip rail [R] to the length of the bottom rail

minus 11/16". Clean the bottom door rail and the drip rail

thoroughly to ensure proper adhesion. Unroll the double stick

tape [V] and carefully apply it to the back of the drip rail (do not

peel the tape backing yet).

Insert the tapered drip vinyl [T] into the drip rail. Position the

drip rail flush with the bottom and pivot side of the door panel

[L], then raise the strike side until the bottom edge of the drip

vinyl is parallel to the curb [A]. Mark the location of each end

of the drip rail.

Adjust the drip vinyl [T] by sliding it left or right

until it just touches the curb. Trim the vinyl (flush with

the pivot end and notch 1/4" longer than the drip rail as

shown on the strike end).

The drip plug [S] is supplied with a left and right hand

plug together. Break the right and left drip plug apart and

insert the appropriate plug into the high (strike) side of

the drip rail. Discard the unused drip plug. Peel off the

tape backing and carefully press the drip rail [R] to the door in

the marked position.

G03711103

8-22-06

Page 8 of 9