Artopex downtown Panduan Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Perabotan Dalam Ruangan Artopex downtown. Artopex downtown 13 halaman.

downtown

MEDIACOM TABLES

Mediacom table with metal leg

Parts to assemble

Technical panel

Step 1 :

Aligned with the inserts, screw the brackets to the technical

panel.

Step 2 :

Screw the metal leg to the surface using the pre-drilled holes.

Step 3 :

Screw the surface to the brackets.

Step 4 :

If it applicable, install the Downtown Connection (M8). Refer to

pages 8 and 10.

* For access to the interior of technical panel, see p.7

Install the vertical cable conduit :

- Using the pre-drilled holes, attach the screws into the technical

panel by screwing lightly.

- Place the vertical cable conduit on to the screws.

Brackets

Surface

Metal leg

Installation guide

The construction of technical panel for all Mediacom tables is

the same. It is possible to access the interior through the back of

the panel by following the steps below :

Back upper panel

- Remove the metal plate located on the top of technical panel.

- Lift the panel and remove it.

Metal plate

Back lower panel

- Remove the 2 screws located at the bottom of panel.

- Lift the panel and remove it.

2 Screws to remove

Finishing profiles are used to conceal electrical cables and

the monitor support brackets. The profiles are installed on

the technical panel of a Mediacom table, on either side of the

There are no pre-drilled holes on the technical panel.

After installing the monitor on the technical panel, center the

profiles and screw them close to the monitor.

Profiles centered height wise

Finishing profiles