CUTRA CtrlAX Buku Petunjuk - Halaman 8

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Produk Perawatan Pribadi CUTRA CtrlAX. CUTRA CtrlAX 16 halaman.

�

information on blades and blade ﬁxtures

▶ Regarding the blade and the blade ﬁxture

�. Use the provided blade and the set screw.

* Make sure the blade and the set screw are securely fastened before use.

�. Stains on the blade or blade ﬁxture can cause overheating, noise, and product damage.

* Before use, check for stains on the blade and blade ﬁxture and replace them if there are any stains.

�. If a set screw other than the provided by our company is used for fastening,

it may not properly tighten and thus may not work properly.

- Using blades other than provided or having a loose set screw may cause the machine

to malfunction, aﬀecting the cutting force and posing a risk of damage or falling

- If the blade is not tightened properly, a warning beep will sound and the operation

- Make sure the blade and blade ﬁxture is inserted all the way in and tighten the

▶ If the bolt is worn during the replacement

- Replace it before the set screw gets worn out.

- If the worn bolt cannot be removed, contact the manufacturer or distributor.

- If you replace the blade while the oscillator is hot, the set screw may become loose when

- Check if the set screw is tightened before use. If it is loose, tighten it again before use.

P. ��

▶ When replacing the blade ﬁxture

out of the blade, which can be very dangerous.

- Ensure that the set screw is tightly fastened.

- Please replace the wrench tip with a new one if it is worn.

button will not work.

hex bolt ﬁrmly with a torque wrench.

the oscillator cools down.

▶ Finally