Artrom YL-2010G Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Dehumidifier Artrom YL-2010G. Artrom YL-2010G 10 halaman.

WATER DRAINAGE

When the water container is full:

- an alarm signal will be produced.

- the fan will continue running.

- the compressor will stop automatically, this will also stop the dehumidification

process.

Empty the water container and replace it in the correct position, the dehumidifier

will continue dehumidifying when the compressor, automatically, starts after

three minutes.

NOTE : When the water container is removed, the fan will continue running.

If desired, it possible to connect the drainage tube (Optional) to the device for

permanent water drainage. Simply connect the included drainage hose to the

drain spout and ensure that the end of the hose is lower than the drain opening,

otherwise the water will not drain and flooding may occur.

Place the end of the drainage hose in a water outlet.

When you no longer wish to use the permanent water drainage, disconnect the

drainage tube from the device. Ensure that the water container is positioned

correctly.

CLEANING

Switch the dehumidifier off and remove the plug from the socket before

cleaning.

THE EXTERIOR

Clean the exterior with a soft, dry cloth. If the device is extremely dirty, use a

mild cleaning agent. Wipe the device with a slightly damp cloth. Never spray the

device with water.

THE AIR FILTER

When used regularly, the filter may become clogged with dust and particles.

Therefore the filter should be cleaned every two weeks. Follow these steps:

1 Remove the filter.

2 Clean the filter with a vacuum cleaner or with water. Dry the filter and

replace it. Ensure that the filter is completely dry.

N ever use the device without the air filter.