ALUZ A1-ZIBI-STN-RGBW Panduan Petunjuk Instalasi - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Peralatan Pencahayaan ALUZ A1-ZIBI-STN-RGBW. ALUZ A1-ZIBI-STN-RGBW 12 halaman. Surface standard rgbw

Halaman Cetak
1
Determine number of reflectors needed. Reflectors are available in 1', 2', 3', or
4' increments. Specify total length of reflectors needed.
2
Position reflectors on luminaires.
3
Install 3 set screws on each reflector to secure in place.
Do not over-tighten set screws
Set Screw
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A1 Series | Surface
ZIBI Standard RGBW
(A1-ZIBI-STN-RGBW)
Reflector
866.ALUZ.LTG | 714.535.7900
4
If applicable, connect disconnects between luminaires. Slide shrink tube over
connectors and apply heat. The shrink tube will shrink down, sealing the
connectors. Apply silicone around sealed connectors for a stronger seal.
5
Mount luminaires at least 12" away from the wall.
Page 11 of 12
Reflector (A1-ZIBI-STN-RE1)
Shrink Tube
2"
Apply Heat
12"
Min. from Wall
Installation Instructions
4 / 29 / 2022 / Rev 2