ALUZ A8 Series Manual - Halaman 6
Jelajahi secara online atau unduh pdf Manual untuk Peralatan Pencahayaan ALUZ A8 Series. ALUZ A8 Series 12 halaman. Tape
Juga untuk ALUZ A8 Series: Manual (2 halaman), Manual (14 halaman), Panduan Instalasi (13 halaman)
Halaman Cetak
UNASSEMBLED APPLICATIONS
1
Measure area where luminaire will be installed. Use a laser line to create
a reference line along installation area, ensuring consistent alignment of
mounting clips. Mark location where each mounting clip will be installed
along reference line.
2
Use 1 mounting clip every 2', rounded up. Use a minimum of 2 mounting clips
per luminaire segment. For vertical applications, create a stopper at the
bottom of the run to prevent sliding.
3
Use a mounting clip at the junction between two luminaire segments.
Example: 20' Run.
8'
3" Gap
Mounting Clip
4
Lay mounting clips along reference line and pre-drill using an appropriate
drill bit for surface material and screw size. Typical screw size is 8/32 x 1".
Note: Allow 1/4" clearance on each side of mounting clip to account for
lateral expansion. Only install mounting clips on flat, even surfaces.
5
Screw mounting clips to surface, then snap luminaire into mounting clips.
a
Screw MC to surface, then snap luminaire into mounting clips.
b
Screw MC-2 to surface, then snap luminaire into mounting clips.
c
Screw MC-3 to surface, then snap luminaire into mounting clips.
d
Screw MC-4 to surface, then snap luminaire into mounting clips.
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A8 Series | LED Tape
ZIZA Standard
(A8-ZIZA-STN)
20'
8'
4'
Junction between luminaire segments
866.ALUZ.LTG | 714.535.7900
ASSEMBLED APPLICATIONS
1
Measure area where luminaire will be installed. Use a laser line to create
a reference line along installation area, ensuring consistent alignment of
mounting clips. Mark location where each mounting clip will be installed
along reference line.
2
Use 1 mounting clip every 2', rounded up. Use a minimum of 2 mounting clips
per luminaire segment. For vertical applications, create a stopper at the
bottom of the run to prevent sliding.
3
Space mounting clips evenly throughout the run.
Example: 20' Run.
8'
3" Gap
Mounting Clip
e
Screw MC-ADJ to surface, then snap luminaire into mounting clips.
f
Screw MC-MM to surface, then snap luminaire into mounting clips.
ASSEMBLED DIMENSIONS
1.87"
.64"
.93"
.63"
MC
MC-2
X"
.93"
MC-4-X
Mounting Clips
20'
8'
4'
Junction between luminaire segments
1.72"
1.50"
MC-3
.81"
1.13"
.69"
MC-ADJ
Installation Instructions
4 / 11 / 2022 / Rev 1
Page 6 of 12
.64"
MC-MM