ALUZ A8-ZUDA-TAPE Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Peralatan Pencahayaan ALUZ A8-ZUDA-TAPE. ALUZ A8-ZUDA-TAPE 13 halaman. Tape

Halaman Cetak

APPLICATION GUIDELINES

• Follow the below diagrams and steps if applicable to your installation.
• LED lightstrip and modules require a team effort to ensure a secure and correct
installation.
• Use a wire puller stand to prevent tangles, twists, and snags.
• For Mud-In applications, start lightstrip from power source side and allow up to
2" of excess lightstrip to exit through end cap.
LED LIGHTSTRIP
SOLDERING GUIDE
1
Cut lightstrip to desired length. Include both sets of solder pads by cutting
to the left or right of designated markings, allowing more space for soldering.
2
Prepare wires by stripping 1/8" from the end of each wire, then tin the tips of
the wire with solder. Apply heat to stripped portion of wire, then add a small
amount of solder until stripped portion of wire is fully covered in solder.
3
If applicable, use a mat knife to remove encapsulation from the section of
lightstrip with solder pads. If lightstrip is not encapsulated, skip this step.
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A8 Series | Tape
ZUDA Tape
(A8-ZUDA-TAPE)
,
,
866.ALUZ.LTG | 714.535.7900
NOTE
• Extrusions are shipped to exact length of specifi ed measurements.
• Due to cut increment restrictions (+/- 0.125" Tolerance), the lightstrip is shipped to
the closest measurement ordered. The lightstrip must be centered in the extrusion.
• Remove adhesive backing completely to allow heat transfer tape to make
contact with the aluminum extrusion.
• Improper fi eld cutting or soldering of lightstrip will void warranty. The below
steps must be followed and performed properly to retain warranty. Field cutting
& soldering is only applicable to Dry, Damp, and Wet Locations. IP67 rated
products are not fi eld cuttable.
45°
4
Solder lead wires to solder pads on the end of lightstrip. Solder the positive
wire (Brown) to the pad marked "+". Solder the cool channel wire (White)
to the pad marked "c". Solder the warm channel wire (Yellow) to the pad
marked "w".
Note: Solder iron not to exceed 720°F. Heat joint with tip of iron. Heat both
the solder pad and the wire. Add a small drop of solder on the tip of solder
iron to transfer the heat to joint quickly; it should melt and flow smoothly,
covering the wire and pad.
Remove iron once enough solder has been added to the components. Allow 5
seconds for the joint to cool.
0.50"
0.50"
5
If applicable, apply silicone over soldered connections. All connections must
be completely covered with silicone to create weatherproof seal. Only use
outdoor rated silicone. If lightstrip is not encapsulated, skip this step.
Note: Appearance of lightstrip may differ from example shown.
Refer to wiring diagrams before soldering any wires.
Page 5 of 12
Application Guidelines
,
45°
.
Installation Instructions
8 / 11 / 2023 / Rev 1