Alva GDH101 Manual - Halaman 10

Jelajahi secara online atau unduh pdf Manual untuk Kompor Alva GDH101. Alva GDH101 18 halaman.
Juga untuk Alva GDH101: Manual (17 halaman)

Halaman Cetak
The leak test must be carried out in a well-ventilated area, free
from any flames or other sources of ignition.
Connection
in assembly
Foamy
bubbles
indicate a
leak
Connections to be leak tested
Regulator into cylinder
Hose to regulator
Hose to appliance

FITTING AND CHANGING THE GAS CYLINDER

1.
Before connecting the appliance to a gas cylinder,
always ensure that the rubber seal on the Regulator is in
position and in good condition, and blow out any dust from
the cylinder opening to prevent possible blockage of the jet.
2.
Ensure that the gas cylinder is fitted or changed in a
well-ventilated location, preferably outdoors, away from any
source of ignition, such as naked flames and away from
other people.

LEAK TEST

•
With the cylinder connected
to the hob, open the cylinder
valve.
•
Brush the connections (hob
to cylinder) with a solution of
equal parts soap and water
(make sure it's foamy).
•
A stream of bubbles forming
indicates a gas leak. (See
picture on left)
•
If bubbles appear, turn the
cylinder valve OFF (clockwise)
and disconnect the hob from
the gas cylinder.
•
Tighten the connection and
retry the leak test.
•
If you are unsure or if you
cannot tighten the connection,
place the cylinder outside in a
cool, well-ventilated area and
contact Alva on 086 100 ALVA
(2582).
•
A leak between the hob and
cylinder can lead to a high
pressure fire, which is very
dangerous and can result in
extensive injury or even death.
8
PRECAUTIONS
Leak test all
connections after each
tank refill
NEVER check for
leaks with a match or
open flame
Any LP Gas cylinder
not connected for use
must not be stored in
the vicinity of this or
any other appliance.