3M 9700 Panduan Petunjuk Pengoperasian - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Proyektor 3M 9700. 3M 9700 15 halaman. Operating instructions

Halaman Cetak

Operating The Projector

Do not illuminate the lamp with the projection mirror

in the down position.

To Operate Projector:

1. Position projector in front of projection screen. The

distance from the screen controls the size of the

projected image.

2. Plug in detachable power cord (if equipped) into

connector on side of projector. Plug in power cord

(all projectors) into electrical outlet.

3. Push power switch "On" to illuminate lamp.

Important

Lamp will not illuminate unless folding legs

and mirror pan are completely down.

4. Rotate projector (1) until projected light beam is

perpendicular (90 ) to the screen surface. The

height at the left and right sides of the projected

image should be equal.

Lamp Changer

If the primary lamp burns out, rotate Lamp Changer

dial to select the second lamp.

1. Open control panel door (1).

2. Lamp interrupt switch (2) cuts power to lamp.

3. Rotate lamp changer dial (3) to select alternate

lamp. Turn dial fully until it stops.

4. Close control panel door to illuminate lamp.

Lamp will not illuminate unless Control Panel door is completely closed.

3M 9700 Operator's Guide

5. Adjust angle of projection mirror (2) to raise or

lower the image on the screen.

6. For best results, tilt projection screen (3) toward

projector until the width of the projected image is

equal at both the top and bottom.

7. Place LCD projection panel or film transparency on

stage glass (4).

8. Set "High/Low" lamp setting to desired position.

See "High/Low Lamp Setting" below.

9. Rotate focus knob (5) for clearest image.

The glass and metal frame on the flip-in magnifier

lens get warm to the touch during use. Always

grasp the insulated tab to rotate the lens.

10. If your projector has the optional magnifier lens

rotate the lens to enlarge the LCD projection panel

image size. Adjust focus knob (5) for sharpest

image.

High/Low Lamp Setting

Activate the High/Low switch to select High (brightest)

or Low (normal) lamp illumination. See diagram to

left.

1. Open control panel door (1).

2. Lamp interrupt switch (2) cuts power to lamp.

3. Press High/Low switch (4) to set desired

brightness.

9700–27C

4. Close control panel door to illuminate lamp.

Important

Caution

= Brightest image, shorter lamp life

= Normal image, longer lamp life