1-CUBE GMDK Panduan Pengguna - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Alat Ukur 1-CUBE GMDK. 1-CUBE GMDK 14 halaman. Measuring device of co2 content in fermenting tanks and keg casks

Halaman Cetak

Note: In case the connectors will not be put in the right way they will be damaged. This type

of damage is not covered by manufacturer's warranty.

The device can be charged only with the supplied adaptor. Average charging time is about 8 hours

and the voltage of a charged accumulator is nearly 19V. „Recharge battery" is displayed under

16.5V and „Low voltage" under 15.5V The charging time can be shortened if needed but the

running period and the accumulator life-time will be shortened too. Once the charging of the device

is over, unplug the adaptor and the connector from the device. Then screw the cap of the connector

(13) for protection and press the power button (12) to turn off.

Notice: If the power button (12) is switched off during charging than the accumulator isn't

charging.

5.2.3 CO

ONTENT MEASUREMENT

Follow the paragraphs 5.1.1. and 5.1.2 and further:

1) Press the power button (12) to turn on and then press the key ON to switch on the

microcomputer. The text „1-CUBE" with the program version appears on the display for a moment.

Then the following text appears:

„ENT.meas." | „+ view."

2) Press the key ENTER. At the beginning of the measurement sequence, the pressure is measured

and displayed, until the pressure goes under the threshold value. This is achieved by opening

briefly the outlet valve (2). When the pressure is low enough, you will hear the buzzer of the GMD

and the display shows "close v.", which indicates that you have to close immediately the valve (2).

Now you can start releasing the CO

from the beer with the pump on the top of the GMD (look

pic.2). Push out the button (9) of the secured position (10b) and pull it out into the upper position

(11). Hold it for a while in this position to equalize the pressure. Then press down the button (9) to

the very down unsecured position (10 a). After this handling dissolved CO

is fluttered and the

pressure increases in the chamber (6). Repeat this action one more time. Use it two times, not less,

not more, then be sure to secure the piston in the down position. Press the Enter key and

„measure" is displayed. The program waits a while for equilibrium, then the measured value of

pressure (e.g. 140kPa), followed by the measured value of temperature (e.g. 5.0 °C) appear on the

display.

Finally, the computed value of CO

content is shown e.g. 0.51 %bw | 5.1 g/l

By displaying CO

content the measurement of sample is over and the CO

value is saved in the

GMD(K) memory.

Press the key ENTER to finish the measurement, the text:

„ENT.meas." | „+ view."

The device is ready for next measurement. When the new sample has been taken, you just need to

repeat this procedure to measure it. If it has been automatically shut off, switch it on as described

above. Press the power button (12) to turn off once the measurement is finished.