Alvarez System 600T Panduan Pemilik - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Alvarez System 600T. Alvarez System 600T 4 halaman. Acoustic preamp/ eq

Halaman Cetak

Contents

Internal Chassis Controls / Connections ............................2

Diagram of System 600T ..................................................3

Digital Tuner Function ......................................................5

Specifications ....................................................................6

You have choosen the finest acoustic

Preamp/Eq System available.

The Alvarez System 600T Preamp/Eq is designed to offer the finest

acoustic guitar tone reproduction available. The System 600T provides

a broad range of sonic control, mixing capability for different combina-

tions of piezo/magnetic/microphone transducers, and features on-board

digital chromatic tuner. We recommend that you take a few minutes to

read this manual in order to familiarize yourself with the many

advanced features and capabilities of the System 600T.

This guitar is equipped with a piezo pickup mounted under the bridge

saddle. This pickup is connected to the PIEZO input of the System

600T, and the guitar will perform perfectly with this pickup/preamp

combination. The System 600T is capable of mixing an additional

internal microphone or sound hole pickup with the piezo pickup for a

wider range of sonic possibilities. Some features of the System 600T

will only operate when an additional pickup/microphone is used.

I n t e r n a l C h a s s i s

C o n t r o l s / C o n n e c t i o n s

With the chassis removed from the mounting ring, you will notice

connections on the rear panel, next to the battery compartment. The

connection marked (1) OUTPUT is for the signal being sent to the

output jack. There are two INPUT jacks, labeled (2) PIEZO and

(3) AUX. The PIEZO input should already be connected to the under-

saddle bridge pickup. The AUX input is included for use with an

additional sound hole pickup, or internal microphone. A magnetic sound

hole pickup, or a miniature dynamic microphone may be connected to

this INPUT jack. An internal condenser microphone will also work, but

the System 600T does NOT supply phantom power. A separate "in-line"

battery must be used to power a condenser microphone.

On the side of the chassis are two

trim pots, labeled (4) LOW and

(5) HIGH. These trim pots are used

to adjust the gain of the BASS and

TREBLE sliders on the front panel.

These adjustments are used to "fine

tune" the System 600T to the sonic

characteristics of the particular guitar

being used.

(6) BATTERY

COMPARTMENT

The System 600T is powered by

a 9 Volt battery mounted in the

bottom of the control chassis.

Access the battery compartment by

removing the two front panel thumb

screws and lifting the chassis from the

mounting ring.

Refer to the front panel diagram on the next

page to familiarize yourself with the various

control functions of the Alvarez System 600T.

S y s t e m 6 0 0 T O w n e r s G u i d e