DLS DD Series Panduan Pemilik - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat DLS DD Series. DLS DD Series 20 halaman. 600w /3 channel audiophile cool running digital amplifier

Halaman Cetak

HPF (High Pass Filter) Adjustment

When you are using coaxial or component speaker system, this allows you to adjust high-pass X-over frequency from 40Hz to

400Hz. To get better sound quality from coaxial or component speaker system, we recommend the frequency should be higher

than 80Hz. Make sure the X-OVER switch is positioned at "HPF".

Input Switch

Matches the input from the Source Unit to the amplifiers. This eliminates the use of "Y" adapters and provides a cleaner

input signal. When the 2-Channel mode is selected, both front and sub outputs will operate with only one pair of low level

RCA inputs.

AUX INPUT NOTE: The MODE switch must be in the 2CH position in order to use

the 3.5mm AUX input

1) Using the 2CH Mode on the DD33-40 requires input signal to the Front Input Connector.

2) Using the 3CH Mode on the DD33-40 requires both the Front Input and Subwoofer Input to be used. This will allow for fading

between the Front and Rear/Subwoofer Outputs.

40H

400H

INPUT

3CH

DD33-40

Fig.10 2-3 Channel Input Mode

Control Panel (6)

High Pass Control (HPF)