aion TORUS Panduan Memulai Cepat - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pedal Musik aion TORUS. aion TORUS 9 halaman. Lo-fi fuzz
Halaman Cetak
TABLE OF CONTENTS
1 Project Overview
2 Introduction & Usage
INTRODUCTION
The Torus Lo-Fi Fuzz is based on the Demo Tape Fuzz by Mid-Fi Electronics. The Demo Tape Fuzz is a
throwback to the days of running a guitar into a cassette recorder and cranking the gain to overload it
and create distortion.
The circuit consists of two simple building blocks. It starts out with an op-amp gain stage. This is similar
to a Distortion+, so the low-pass frequency changes with the gain. (This is in contrast to most drive
circuits after the 1970s where the potentiometer instead controls the feedback resistor, so the low-pass
frequency remains constant.) Next, a basic Baxandall tone section allows adjustment of treble & bass.
The interesting thing about this circuit is that, like a cassette recorder, there are no clipping diodes, so
all of the distortion/fuzz sound is generated "unintentionally" by op-amp clipping. It can get pretty thick,
but retains its rough-around-the-edges character at all settings.
USAGE
The Torus has the following controls:
• Gain (called "Trim" in the original) controls the amount of gain in the op-amp stage, as well as
varying the low-pass filter.
• Treble forms half of the Baxandall tone control and allows adjustment of the treble frequencies.
• Bass forms the other half and allows adjustment of the bass frequencies.
• Volume controls the overall output of the effect.
TORUS LO-FI FUZZ
9 Licensing
2