10-8 Video Digital Evidence Solutions 2.4GHZ Wireless Microphone System Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Instalasi untuk Sistem mikrofon 10-8 Video Digital Evidence Solutions 2.4GHZ Wireless Microphone System. 10-8 Video Digital Evidence Solutions 2.4GHZ Wireless Microphone System 3 halaman. 2.4ghz wireless microphone system

Halaman Cetak

If your department opted for our new 2.4ghz wireless microphone system,

congratulations. This is an incredible wireless microphone with excellent

range and clarity. The operation is easy and straight forward.

As long as there is power to the cradle/receiver, and the transmitter is

inserted properly in the cradle, the transmitter will charge and stay

charged. In addition, inserting the transmitter into the cradle will synch the frequency and

channel between the transmitter and receiver. When the 'green' LED light is solid, the

battery is charged.

On the bottom of the transmitter is a small switch; slide it to the on position. Now insert

the transmitter into the cradle to allow the units to synch. The 'Talk' light will flash

briefly and the transmitter is then ready for use. The red 'Talk' button is what will switch

the unit between stand-by and actively transmitting. If your receiver was installed with

the transmit sensor connected to the DVR, then activating the transmitter with the 'talk'

button will also activate the recorder to begin recording. Pressing the button again will

put the transmitter in stand-by and turn the recorder off. The exception to this would be if

the recorder was already activated by your emergency equipment. In this case, the

recorder would continue to record but your mic transmitter would be in stand-by and not

transmitting audio to the recorder.

The Mode button cycles through 3 modes: silent, vibrate & audio warning, and vibrate

only. This is for instances when your Mic is out of range to the receiver or has not been

properly synched to the receiver.

This unit has a built in microphone in the transmitter. For most situations, this is the only

microphone you will need. However, the unit is also supplied with a wired lapel

microphone. Should this mic be needed, simple plug the microphone into the top of the

transmitter. This will de-activate the built in mic and audio will only be picked up by the

wired mic.

Thanks for you support. Be Safe out there....

ADDENDUM: User's Guide:

2.4GHZ Wireless Microphone System (Optional)