Aion Electronics Azimuth Overdrive Manual - Halaman 2

Jelajahi secara online atau unduh pdf Manual untuk Pedal Musik Aion Electronics Azimuth Overdrive. Aion Electronics Azimuth Overdrive 6 halaman. Hermida/lovepedal zendrive

Halaman Cetak
Aion Electronics Azimuth Overdrive Manual
Parts
Resistors
R1
470k
R2
1k
R3
1k
R4
10k
R5
1k
R6
10k
R7
10k
RPD
1M to 2M2
LEDR
4k7
Op-amp selection: In the original, the back of the op-amp was sanded down, so while it's not known for
1
sure, some expert DIY detectives found that it was almost certainly an AD712. The Lovepedal version uses an
unsanded NE5532. Due to the high diode-clipping threshold, this circuit has a particularly strong dependence
on the type of op-amp used, so it's worth experimenting with a few. Other DIY favorites include the OPA2134,
OPA2604, TC2272, MC1458 and LM833.
Clipping diode: Some versions of the Zendrive use another BAT41 here instead of a germanium. It can be
2
any type of germanium diode, not just 1N34A.
Drive pot value: The original uses 500kB (linear taper) but I recommend using a 500kA (audio taper).
3
Volume pot value: The original uses 100kB (linear taper) but I recommend using a 100kA (audio taper).
4
Additional Part Notes
• Capacitors are shown in nanofarads (n or nF) where appropriate. 1000n = 1uF. Many online suppliers do
not use nanofarads, so you'll often have to look for 0.047uF instead of 47n, 0.0056uF instead of 5n6, etc.
• The PCB layout assumes the use of film capacitors with 5mm lead spacing for all values 1nF through
470nF. I prefer
EPCOS box film
• Potentiometers are Alpha 16mm right-angle PCB mount.
• I recommend using
the board and prevent shorts. If you don't use these, use some electrical tape or cardboard to act as
insulation. The right-angle pots will make direct contact with the solder pads otherwise.
ZENDRIVE / AZIMUTH OVERDRIVE
or
Panasonic
these dust covers / insulators
Capacitors
C1
470n film
C2
100pF
MLCC
C3
100n
C4
3n3
C5
470n film
C6
100uF
electro
C7
47uF
electro
ECQ-B/V-series.
from Small Bear to insulate the back of the pots from
Semiconductors
IC1
AD712
1
D1
1N4002
D2, D4
BAT41
D3
1N34A Ge
Q1, Q2
2N7000
LED
5MM
Potentiometers
Drive
500kA
3
Tone
50kB
Voice
10kB
Volume
100kA
4
2
2