DNP DS80 Referensi Cepat - Halaman 5
Jelajahi secara online atau unduh pdf Referensi Cepat untuk Printer DNP DS80. DNP DS80 6 halaman. Photo imaging
Juga untuk DNP DS80: Panduan Memulai Cepat (8 halaman), Panduan Pengemasan Ulang (2 halaman)
Halaman Cetak
DS620A & DS820A Printers
Installing the Paper
1. Pull out the media compartment drawer by
lifting the handle under the scrap box and
pulling gently.
2. Release the paper compartment release
lever.
3. Remove the scrap box. Set
it aside.
4. Remove the paper roll from
the printer.
5. Remove the spools ends
from the paper roll by pulling gently on the
spools until they come off.
6. Set the spools into a new roll of paper.
ATTENTION:
Be sure there is no gap between the paper and
the spools. Failure to set correctly can result in
paper jams.
7. Set the paper into the paper compartment.
Make sure the paper roll is seated so that the
leading edge of the paper roll is coming over
the top of the paper roll and feeding into the
paper compartment from the bottom.
DNP Imagingcomm America Corporation
© 2017. All rights reserved.
DS-Series™ Printer Quick Reference
8. Remove the seal on the paper.
9. Advance the paper
so that the paper is
feeding into the printer
from the bottom of the
paper compartment.
The printer beeps
when the paper is in
the correct position.
10. Replace the scrap bin, and close the top of
the paper compartment.
11. Close the paper compartment.
ATTENTION:
The printer will not operate without the scrap bin
in place.
Installing a New Ribbon
1. Remove the old ribbon from the printer and
discard it.
2. Set a new ribbon into the ribbon cassette.
3. Advance the ribbon in the
direction shown, leaving
no slack.
4. Place the cassette in the
printer with the supply
side in the front.
5. Close the media compartment drawer.
6. The printer will cycle through the lights as
it adjusts the media. When the media is
aligned, four blank test images are printed.
NOTE:
If you have installed the media and a red error
light is shown on the front of the printer, reseat
the paper and ribbon to clear the error condition.
5
Fixing a Ribbon Tear
1. Open the media compartment.
2. Remove the ribbon
cassette.
3. Cut the ribbon. Carefully
remove any remaining
ribbon from inside the
mechanism.
4. Reattach the ribbon using
cellophane tape, as shown.
5. Advance the ribbon several times until the
tape is no longer showing.
6. Make sure there is no slack in the ribbon.
Replace the cassette in the printer.
ATTENTION:
Make sure the ribbon is placed in correctly.
7. Close the media compartment drawer. The
printer will re-initialize.
Fixing Paper Jams
1. Pull out the media compartment.
2. Release the paper compartment release
lever.
3. Remove the scrap box. Set it aside.
4. Remove the paper roll
from the printer. Pull
any paper remaining
from the printer.
5. Cut off any partially printed, wrinkled or
otherwise inferior paper evenly with scissors.
6. Replace the paper and feed the paper into
the printer.
7. Replace the scrap box, and close the media
compartment drawer.
8. The printer will cycle through the lights as it
adjusts the media. When the
media is aligned, four blank
test images are printed.
Release: v01.2017
PN: 35-260-2-SA