Blue Box BBG-EMDE-AES75 Panduan Memulai Cepat - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Penguat Blue Box BBG-EMDE-AES75. Blue Box BBG-EMDE-AES75 4 halaman. 3g/hd/sd aes audio embedder / de-embedder

Halaman Cetak

Audio Meters Tab

• •

•

Tone Generators Tab

• •

•

Settings Tab

Flex Mixer Tab

Relative signal levels can be checked for

all embedded and AES audio inputs

using the Audio Meters tab.

Individual tone generators Tone 1 thru Tone 8 can be set for

desired frequencies and routed to embedded or AES output

channels using the Output Routing controls. Tone 1 thru

Tone 8 all provide a -20 dBFS level.

Note: Multiple tone generators, even if set to the same

frequency, may not exhibit phase coherence. If identical

tones with frequency and phase coherence are required,

use a single tone generator (e.g., "TG1") across multiple

channels instead of multiple generators set to the same

frequency.

The Settings tab shows

the current settings for

the 10-position DIP

switch located on the

bottom of the BBG-

EMDE-AES unit. The

Status LED mirrors the

status shown on the

LED on the edge of the

BBG-EMDE-AES unit.

The Flex Mixer tab provides two

inddependent 8-channel mixers in

which each of the eigth selected inputs

can be mixed onto two independent

output summing nodes (Flex Mix A

and/or Flex Mix B). The Flex Mix A

and/or Flex Mix B summed nodes can

be used as output channel source

selections just like any other source

channel.

Each Flex Mixer input source selection

can be adjusted for independent gain

and normal/invert phase.

Note: Unused mixer inputs should be

set to Silence.

Powering Down BBG-EMDE-AES with Custom GUI Settings

BBG-EMDE-AES requires the AC adapter to make certain adequate power is supplied to the

unit. To make certain BBG-EMDE-AES powers-down as intended and properly saves any

custom settings, power-down as follows:

After settings have been made, wait until the STATUS LED on the unit stops flashing

amber and is solid green. (Flashing amber state means BBG-EMDE-AES is currently

saving custom settings; green means state has been saved in memory and unit can be

powered down.)

2. Disconnect the USB connection.

3. Disconnect the AC adapter from the AC line or the unit itself. BBG-EMDE-AES are now

saved and will re-appear upon next power-up. Unless the settings need to be changed,

only the AC adapter connection is necessary for powering BBG-DE-AA in field use.

Cobalt Digital Inc.

2506 Galen Drive

Champaign, IL 61821

Voice 217.344.1243 • Fax 217.344.1245

www.cobaltdigital.com

BBG-EMDE-AES_CONFIG-OM (V1.6)