Aion Electronics Titan Overdrive Manual - Halaman 2
Jelajahi secara online atau unduh pdf Manual untuk Pedal Musik Aion Electronics Titan Overdrive. Aion Electronics Titan Overdrive 6 halaman. Modified voodoo lab overdrive
Halaman Cetak
Parts
Resistors
R1
10k
R2
470k
R3
18k
R4
2k2
R5
10k
R6
10k
R7
150k
R8
39k
R9
33k
R10
22k
R11
100R
R12
10k
R13
10k
RX1
10k or 56k
RX2
jumper
RPD
1M to 2M2
LEDR
4k7
Tone control minimum: The tone control can get pretty dark at its minimum settings. RX2 has been added
1
to counteract this, allowing you to raise the minimum position of the control. 1k is a good place to start for this.
Capacitor type: C7 was a tantalum in the original, but I included space for the larger film caps. Polarity
2
markings have been added to the silkscreen in case you want to use tantalum.
Part of the voltage doubler circuit. You can omit these parts if building a straight 9V version.
3
Germanium diode: Any germanium diode should work fine here—the exact part number isn't important. This
4
diode was added in V4, so it can be jumpered if you're building a lower version number.
LEDs: I recommend using red diffused 5mm LEDs for the second clipping option.
5
Drive pot value: One commercial version of the modified VLOD switched to a 1MA pot for the Drive control.
6
General consensus is that this was not an improvement and the pedal loses its character above 50%. I
recommend sticking with 500kA here.
Tone pot value: Early versions of the modified VLOD used 25kA for the tone control and 100n for C8.
7
Volume pot value: The first version of the modified VLOD used 100kA for the output volume control. The
8
500k gives a lot more output volume with the downside that it's a little harder to dial in at lower volumes.
Additional Part Notes
• Capacitors are shown in nanofarads (n or nF) where appropriate. 1000n = 1uF.
• The PCB layout assumes the use of film capacitors with 5mm lead spacing for all values 1nF through
470nF. I prefer
EPCOS box film
• Potentiometers are Alpha 16mm right-angle PCB mount.
• I recommend using
the board and prevent shorts. If you don't use these, use some electrical tape or cardboard to insulate.
TITAN OVERDRIVE - MODIFIED VOODOO LAB® OVERDRIVE
1
or
Panasonic
these dust covers / insulators
Capacitors
C1
22n
C2
220pF
MLCC
C3
68n
C4
1n
C5
220pF
MLCC
C6
100n
C7
1uF
2
film
C8
47n
C9
47uF
electro
C10
10uF
electro
3
C11
10uF
electro
C12
10uF
electro
ECQ-B/V-series.
from Small Bear to insulate the back of the pots from
Semiconductors
IC1
TL082
IC2
TC1044
Q1, Q2
2N7000
D1
1N4742
D2
1N34A
D3, D4
LED
5
D5, D6
1N4002
LED
5MM
Potentiometers
Drive
500kA
Tone
10kB
7
Volume
500kA
Other
Clip, HP/LP
SPDT
center off
3
zener
4
3
6
8
2