Doberman SE-0205 Manual

Jelajahi secara online atau unduh pdf Manual untuk Sistem Keamanan Doberman SE-0205. Doberman SE-0205 6 halaman. Multi-purpose alarm w/remote

SE-0205 MULTI-PURPOSE ALARM W/REMOTE

PACKAGE INCLUDES:

Multi-Purpose Alarm Main Unit with two magnetic detectors...1PC

Remote Control...1PC

12V 23A Alkaline battery (for Remote)...1 PC

Warning Sticker... 2 PCS

BATTERY INSTALLATION:

Main Alarm Unit:

Remove the front battery cover by sliding it downwards.

Unscrew the water resistant cover.

Follow the polarity instructions and insert three AAA Alkaline batteries (not included).

Screw on the water resistant cover.

After the batteries are installed, the red LED will flash. The Main Alarm unit is now

prepared for the Remote Unit to learn the mutual control code.

Press either the ARM or DISARM button on the Remote unit. Three short beeps will

sound and the red LED will flash to indicate that the Main Alarm unit has successfully

learned the code.

Remote Unit:

Unscrew the back cover to insert or replace 1pc fresh DC12V battery (included) into

the battery compartment.

The red LED will turn on to indicate that the battery has been installed successfully.

Press either of the two buttons on the Remote Unit to turn OFF the red LED.

OPERATION:

Attach the alarm to the inside of your tool box, or on your window, door/gate, with the

included adhesive.

When setting up the Multi-Purpose Alarm for the first time, place the magnetic

sensors adjacent to each other. Make sure that the two sensors are not separated by

more than half an inch when the tool box/window/door/gate is closed.

After closing the tool box/window/door/gate, press the remote and wait for the

confirming beep: If one beep is heard, then the Multi-Purpose Alarm is armed. If

instead four beeps sound, then the magnetic sensors are too far apart and need to be

placed closer together. Open the tool box/window/door/gate, re-adjust the sensors,

and try again until a "beep" sound is heard. Now the Multi-Purpose Alarm is ready to

protect your valuables.

Use the remote to arm and disarm the Multi-Purpose Alarm. These actions are

confirmed by an audible beep and LED flash.

The alarm will enter into arm status 5 seconds after the ARM button is pressed.

In the event of a break-in, the armed alarm and the LED will go off continuously for

one minute and then automatically reset to armed status.

Turn OFF the alarm by pressing DISARM. Two short beeps will then sound

accompanied by an LED flash.

LOW BATTERY INDICATION:

Main Alarm Unit: When the battery power becomes low, the red LED will flash at 20

Protect virtually anything