Dobinsons BU59-3716 Panduan Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Mobil Dobinsons BU59-3716. Dobinsons BU59-3716 12 halaman. Bullbar for toyota landcruiser 200 series mid-2015 on

Halaman Cetak

27. Wire the winch up as per the winch

instruction manual and bolt the winch to the

mounting bracket, ensure the mounting bolts

are not too long and tighten correctly. Route

the wires and connect to battery and also

route the breather hose.

28. Reinstall the bumper and grill and the grill

cover.

29. Unwind some cable from the winch, and pass

the cable through the fairlead hole in the

bullbar and through the roller fairlead. This

may require removing a circlip from the

fairlead and re installing once the cable is

passed through.

30. Install the fairlead into the bulbar.

31. Check the poly bulbar over riders, fog light

and top loop bolts are tight (Do not over

tighten the stainless steel loop mounting

bolts. Do not over tighten the poly bullbar

over riders as they will pull the over riders out

of shape).

32. With help, fit the bulbar onto the mounting

bracket and loosely fit the mounting hardware

supplied.

33. Align the bulbar to the vehicle and tighten the

mounting bolts. Leave a a gap of around 12 –

15mm on the wing tips to the bumper

Dobinsons Springs and Suspension

34. Once happy with the alignment of the bullbar

drill pinning holes on each side of the bullbar

drilling through both the pinning holes

predrilled in the bulbar bracket into the

bulbar mounting plates. Fit bolts and nyloc

nuts to keep the bullbar in its position.

35. Install the outer bulbar wing support brackets

from the chassis bracket to the bracket on the

inside of the bulbar wings and tighten.

36. Wire up the lights. Using a multimeter or test

light first locate the earth wire, parker positive

and indicator positive wires from the wiring

on the back of the original vehicle lights on

each side.

37. Unclip the wiring from the indicator/parker

lights. Check that the wiring will be long

enough to reach the new bullbar

indicator/parker lights and extend if required.

Using the diagram at the end of this manual,

join the corresponding wires to original

vehicle wires located in the previous step. The

wires can be joined by either using good

quality snap lock crimp connectors or by

soldering. Ensure the connection is secure and

is sufficiently insulated.

38. If fitting a bullbar with fog lights, the fog lights

can be connected using the original vehicle

fog light wires if fitted. If required, cut the old

fog light wiring plugs off and cut the new fog

light wiring plugs and join. If the vehicle is not

fitted with OEM fog lights the wiring loom

supplied can be used. Follow the wiring

diagram at the end of this manual.