Dobinsons BU63-3523 Panduan Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Aksesori Mobil Dobinsons BU63-3523. Dobinsons BU63-3523 13 halaman. Bullbar for vw amarok

Halaman Cetak

and indicator positive wires from the wiring

on the back of the original vehicle lights on

each side.

31. Unclip the wiring from the indicator/parker

lights. Check that the wiring will be long

enough to reach the new bullbar

indicator/parker lights and extend if required.

Using the diagram at the end of this manual,

join the corresponding wires to original

vehicle wires located in the previous step. The

wires can be joined by either using good

quality snap lock crimp connectors or by

soldering. Ensure the connection is secure and

is sufficiently insulated.

32. If fitting a bullbar with fog lights, the fog lights

can be connected using the original vehicle

fog light wires if fitted. If required, cut the old

fog light wiring plugs off and cut the new fog

light wiring plugs and join. If the vehicle is not

fitted with OEM fog lights the wiring loom

supplied can be used. Follow the wiring

diagram at the end of this manual.

33. With help, fit the bulbar into position and

install nuts and bolts supplied.

34. Align the bar with the vehicle into its correct

position, this will leave about a small gap on

each side between the top of the bulbar wing

and the pinch well or flare, to allow for

movement between cab and chassis.

35. Once you are happy with the alignment

tighten the nuts and bolts on each side.

36. Once happy with the alignment of the bullbar

drill 2 x 8mm pinning holes on each side of the

bullbar drilling through both the mounting

bracket mounting plate and bullbar mounting

plate. Fix with 8mm bolts and nyloc nuts to

keep the bullbar in its position.

Dobinsons Springs and Suspension

37. Plug the wires into the indicator, parker light

plug and fog lights. Test all lights and adjust

the position of the fog lights if required.

38. Fit the under bar protection kit now with the

bolts supplied.

39. Refit the number plate and check over all

items removed during installation.

40. Remove packaging from upper section of

bulbar.

41. Trim Wheel arch liners level with bottom of

the under protection kit and secure.