Fleck 3200ET Panduan Servis - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Servis untuk Unit Kontrol Fleck 3200ET. Fleck 3200ET 12 halaman. Remote meter

3200ET Remote Meter

Control Operation (Cont'd.)

Control Operation During A Power Failure

During a power failure all control displays will be turned off and regeneration cycles delayed. The control will otherwise

continue to operate normally until line power is restored or battery backup power is lost.

1. If battery backup power is never lost during a power outage, the control will continue to operate normally, without

the loss of data, until line power is restored.

2. If battery backup power is lost during a power outage, the control will store the current Time Of Day, Volume

Remaining, Regeneration Signal Status, and various diagnostic displays. These stored displays will then be used

upon line power restoration until updated ones are created. To indicate this type of failure, the control will flash the

current Time Of Day Display to indicate that this display and the Volume Remaining Display may not be correct.

Control Operation During Regeneration

During Regeneration a special regeneration display will take the place of either the Time Of Day or Volume Remaining

Display. This display will contain the number one (to indicate only one regeneration signal is being sent) and the signal

time remaining.

1. First the Regeneration Arrow turns on. Then the display below appears to indicate that a Regeneration Signal is

being sent and how long it will be.

For Example:

(Regeneration Signal has started)

(6.0 minute regeneration signal to be sent)

(Regeneration Arrow On)

2. As time passes the countdown display will decrement in tenths of minutes until the time remaining reaches zero.

When this occurs the control will return immediately to Service

For Example:

(Regeneration Signal has started)

(3.2 minutes remain for signal)

(Regeneration Arrow On)

3. Pushing the Extra Cycle Button during a regeneration signal will immediately return the control to Service.

4. Pushing the Up or Down Set Button during a regeneration signal will adjust the signal time remaining. Actual

Regeneration Signal programming will not be changed.

Printed in U.S.A.

Regeneration

Signal

Regeneration

Signal

Page 7