DockCraft 100 Series Manual - Halaman 5

Jelajahi secara online atau unduh pdf Manual untuk Peralatan Perahu DockCraft 100 Series. DockCraft 100 Series 15 halaman.

Thread Webbing through Cam Buckle :

8 – Obtain one of the Cam Buckles and Depress Lever

9 – Thread Webbing through opening in the Cam Buckle

Ensure that the Single Bar on the Web Keeper is positioned as shown.

10 – Pull webbing through the Cam Buckle until the pre-marked line is in position with

the cam buckle.

11 – Repeat Steps 6 – 8 to thread the webbing through the other Cam Buckle .

Steps 8 - 11

Assemble the Lifting Assembly to the Rack Assembly

Start by assembling the pulley to the webbing strap in the middle of the lifting assembly:

Remove the wing nut and push the screw so that it clears the side plate,

Rotate the side plate such that the nylon spacer and screw is exposed.

Slide the round spacer behind the webbing strap on the cross bar. Rotate the side plate back

in position, push the screw through the hole and secure with the wing nut.

Remove mini wrap and rotate channels as shown

Align Lifting Assembly with Pivot Laterals,

depress Snap Buttons and seat

Assembly Instructions - continued

Page 5 of 15

Snap buttons on this end

Completed Assembly