FLEET HOSTER FleetFlix AI+ Pro Instal Manual - Halaman 19

Jelajahi secara online atau unduh pdf Instal Manual untuk Kamera Dasbor FLEET HOSTER FleetFlix AI+ Pro. FLEET HOSTER FleetFlix AI+ Pro 20 halaman.

After installing the camera, the following measurements are needed

Hood length - the distance from the front lens of the camera and the front bumper

Vehicle width - the total width of the vehicle at its widest point in front of the camera (typically wheel arch to

wheel arch)

Camera height - the distance from the ground to the bottom of the camera Driver position - which side of the

vehicle the steering wheel is on, (left hand is typical for American market vehicles)

After install has been completed and measurements have been saved in the database, the camera will need to be

calibrated. To calibrate the camera properly you will need to take the vehicle on a short drive under these

conditions:

•

Good contrast for lane markers

•

Capable of supporting 30+ mph for 3-5 minutes

•

Avoids hills or turns

•

Reasonable weather

•

Light traffic

To Start Calibration

While the vehicle is driving down the road in these optimal conditions, press and hold down the driver alert

button for 4 seconds. The camera will announce "Calibration Started" and once complete camera will announce

"Calibration Done". Once calibration is complete, your camera has been successfully set up and returning the

button to driver alert. If the camera is ever removed or unmounted, calibration will need to be completed again.