DOCOL DocolEletric 00396706 Manual - Halaman 11

Jelajahi secara online atau unduh pdf Manual untuk Produk Pipa DOCOL DocolEletric 00396706. DOCOL DocolEletric 00396706 12 halaman. Table lavatory faucet

Halaman Cetak
SÍNTOMAS
El água no sale cuando el sensor es
activado: Válvula Solenóide produce
click audível
El agua no sale cuando el sensor es
activado: Válvula Solenóide no produce
click audível
El agua sale continuamente
Bajo caudal
Manintenance
SYMPTOMS
Faucet does not deliver any water when
Sensor is activated.
Solenoid valve produces an audible
"CLICK".
Faucet does not deliver any water when
Sensor is activated.
Solenoid valve no produces an audible
"CLICK".
Faucet does not stop delivering water
Low flow
SYMPTOMS
Faucet does not deliver any water
when Sensor is activated.
Solenoid valve produces an audible
"CLICK".
Faucet does not deliver any water when
Sensor is activated.
Solenoid valve no produces an audible
"CLICK".
Faucet does not stop delivering water
Low flow
DOCOLTRONIC
PROBABLES CAUSAS
Indisponibilidad del água en el punto
Suciedad en la tubulación
RRC cerrado
Pilas descargadas
Pilas montadas con la polaridad cambiada
Falla en la conexión entre sensor y solenóide
Cabo del sensor roto
Sensor damnificado
Objeto en el rayo de la acción del sensor
Falla en la conexión del sensor con la solenóide
Regulagem del RRC
Suciedad en la tubulación
Aire en la tubulación
Valvula solenóide montada con el flujo del agua a la
inversa
Aerador obstruido
Registro general es parcialmente cerrado
DOCOLELETRIC TROUBLESHOOTING GUIDE
POSSIBLE REASONS
Water supply failure
Inlet Flow Control
Inlet Flow Control closed
No power
Power cord is not connected in the electrical outlet
Bad connection between sensor and power switch
Faulty Sensor cable
Faulty sensor
Object in recognition range sensor
Faulty solenóide valve cable
Inlet Flow Control not enough open
Pipe system or core of Inlet Flow Control flow is
clogged
Air inside pipe system
Solenoid valve mounted with opposite way flow
Water supply stop is partially closed
Aerator is clogged
DOCOLTRONIC

TROUBLESHOOTING GUIDE

POSSIBLE REASONS
Water supply failure
Inlet Flow Control
Inlet Flow Control closed
Batteries low. LED blink red once every 1 second
The polarity battery is reversed
Connection Failure between solenoid valve and
sensor.
Faulty Sensor cable
Faulty sensor
Object in recognition range sensor
Faulty solenóide valve cable
Inlet Flow Control not enough open
Pipe system or core of Inlet Flow Control flow is
clogged
Air inside pipe system
Solenoid valve mounted with opposite way flow
Water supply stop is partially closed
Aerator is clogged
SOLUCIONES
Abrir el registro general
Abrir el RRC (Registro Regulador de Cauda) .
Retirar el criba del RRC y limpiar .
Girar el cartucho de lo RRC en el sentido horario
Cambiar las pilas
Colocar conforme polarización indicada en el suporte de pilas
Conectar el cabo solenóide en lo cabo del sensor
Podrá ser adquirido en el Distribuidor Autorizado DOCOL
en ese País
Podrá ser adquirido en el Distribuidor Autorizado DOCOL
en ese País
Retirar el objeto
Conectar el cabo solenóide al cabo del sensor
Girar el cartucho del RRC en el sentido horario.
Retirar el cartucho y limpiar el criba .
Abrir la red en otro punto y sangrar la red (dejar salir el
água hasta parar de salir aire junto)
Invertir la posición de montajem de la valvula
Remover, limpiar e reinstalar el aerador
Abrir totalmente el registro general
SOLUTIONS
Open water supply stop valve
Open the Inlet Flow Control.
Disassemble and clean the core of Inlet Flow Control Filter.
Open Inlet Flow Control flow turning clockwise the core.
Verify overload protect
Connect power cord to power inlet
Connect the cableas again
Available at Docol Authorized Distributor in your country
Available at Docol Authorized Distributor in your country
Remove the object
Connect the solenoid valve cable to sensor cable again
Turn clockwise the core of Inlet Flow Control
Open Inlet Flow Control flow, clean the core
Open the system pipe in another point let the water and
air go out until only water goes out.
Change the position way flow solenoid valve mounted.
Caution on the signal way flow under the solenoid valve
Completely open water supply stop
Remove, clean, and reinstall aerator
SOLUTIONS
Open water supply stop
Open the Inlet Flow Control
Disassemble and clean the core of Inlet Flow Control Filter
Open Inlet Flow Control flow turning clockwise the core
Replace batteries
Insert the batteries like showed in the figure 2A page 10.
Caution in battery polarity
Connect the solenoid valve cable to sensor cable again
Available at Docol Authorized Distributor in your country
Available at Docol Authorized Distributor in your country
Remove the object
Connect the solenoid valve cable to sensor cable again
Turn clockwise the core of Inlet Flow Control
Open Inlet Flow Control flow, clean the core
Open the system pipe in another point let the water and
air go out until only water goes out.
Change the position way flow solenoid valve mounted.
Caution on the signal way flow under the solenoid valve
Completely open water supply stop
Remove, clean, and reinstall aerator
11