fleetfinder GOLD Panduan Pengguna - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk GPS fleetfinder GOLD. fleetfinder GOLD 19 halaman.
Halaman Cetak4.0 OPERATING REQUIREMENTS
Environment
Do not install fleetfinder GOLD in direct sunlight or directly under
any areas exposed to direct sunlight or extreme heat. fleetfinder
GOLD incorporates sensitive electronics and is to be installed in
the vehicles cabin only.
Keep the unit installed in a secure location that is to be free of
dust, and moisture. For a stealth install it is recommended that the
fleetfinder GOLDis kept away from any radio antennas or speak-
ers, as it may indicate that there is a GSM network
connection present to the vehicle operator.
Power
fleetfinder GOLD operates on a 12 volt or 24 volt supply only. If
fleetfinder GOLD has a voltage higher than the operating voltage
applied then the device will fail to operate and could cause internal
damage to the unit. If the power supplied is below the minimum to
operate, the unit will send a warning, if programmed to do so, and
may switch to backup battery power.
See fleetfinder GOLD specifications.
The built in backup power supply allows fleetfinder GOLD to
continue to operate and alert you if your vehicles battery power
is severed. The backup battery is float charged by your vehicles
electrical system.
P6
GPS antenna location
fleetfinder GOLD is able to determine the exact location of your
vehicle by the use of the incorporated GPS receiver. For the GPS
to work most effectively, the external GPS antenna must be located
in a position with as much view of the sky as possible. The GPS
Antenna will generally operate through non metallic objects. Some
suggestions include high up under the dash and below the rear
parcel shelf. The black face of the antenna is the side which must
face skyward. Ensure before completing the installation that the
antenna is secured firmly in place.
Before picking a location in your vehicle for the GPS antenna, it is
best to first connect the GPS antenna to the fleetfinder GOLD and
apply power. Shortly after powering on fleetfinder GOLD you will
observe the green satellite LED on the unit turn on, this means the
unit is receiving GPS data.
If this does not happen, place the antenna on the roof of your ve-
hicle, making sure that your vehicle is outdoors. Wait until the LED
comes on and stays on. This now indicates fleetfinder GOLD has a
fix on your vehicles location. Please be patient as with a cold start
(first power up) this process of satellite acquisition can take up to
5 minutes (in worst case). In some cases where the control of the
fleetfinder GOLD is set to SMS as a default, and the unit has
started up successfully (RED and GREEN lights on, with the
YELLOW LED flashing or still) you are able to find out the GPS
status by simply sending a "SYS" sms command from the Primary
declared phone number (see command list to see how to set this,
and for further instructions on the
SYS command).
In the reply message you will see the status of the GPS.
P7