FleetMon AIS Station Manual - Halaman 6

Jelajahi secara online atau unduh pdf Manual untuk Penerima FleetMon AIS Station. FleetMon AIS Station 8 halaman.

AIS Station

Checking The Devices

On the bottom of the AIS receiver, you will find a red and green LED light.

The red LED (POWER) shows that the device is on. If no red light appears, recheck the

power connection cable.

The green LED (DATA) blinks from time to time when it receives AIS data. If the green LED

does not blink irregularly, check the antenna and the cable connections again.

Its indicate that we receive no AIS data.

On the front side of the Serial-to-IP-converter you will find 5 LED lights:

constant red = ON

POWER

If it does not light up, check power connection

The LED only lights when the red data/consol button on the bottom of

READY

the device is point on data and is only needed for programing the device

blink green = wait for network connection

constant green, ready for programming

The green LED blinks at the same time as the green data LED on the

SERIAL Rx/tx

AIS receiver

If it does not blink, but the AIS receiver

blinks, please check the serial cable between AIS receiver and IP converter

constant green = network cable is connected

LINK

If it does not light up, check network connection or change network cable

Blinking orange = network connection works and is ready to send data

ACT

If it does not light up, check network connection or change cable