Fleetwood WRS970 Panduan Pengguna - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Papan tombol Fleetwood WRS970. Fleetwood WRS970 20 halaman. Reply system keypad and base station
Halaman CetakNEW IMAGE
5.0 System Operation
5.1 Operating Modes
The system has two operating modes available: Static
Addressing and Dynamic Addressing. For security
purposes, both the base and the keypads must be
configured to the same addressing mode as they are
not interoperable. This means that a Dynamic
Addressed system will not operate with a Static
Addressed system basically making two products in
one. Keypads must be configured locally and the
base is configured through the API.
5.2 Static Mode Keypad Power-Up
When a Static mode keypad is first powered up, it
begins communication with a base matching the set
Base ID (CH). If the keypad is within range of the
proper base, voting is immediately available to the
user. If the system is configured with login enabled,
the keypad prompts the user to enter the login value
before allowing a vote. See Section 5.4 for login
description.
5.3 Dynamic Mode Keypad Power-Up
When the keypad is first powered up, the following
message is shown on the display while the keypad
looks for available bases. Pressing any key will stop
the search prematurely.
Σ ε α ρ χ η ι ν γ
Φ ο ρ Β α σ ε σ . . .
Once the search has timed out or stopped, the display
presents how many bases it found and the Base ID
(CH) of each base. Use the left and right soft keys to
scroll through the list.
10
Preliminary Document
Φ ο υ ν δ : 2
<
0 8
Φ ο υ ν δ : 2
<
1 0
For bases with login enabled, the key icon flashes on
the display when the associated base ID is shown.
Press the center soft key to select the Base ID.
Α υ τ η ο ρ ι ζ ι ν γ
While the keypad is negotiating itself onto the
system, the display presents authorizing and shows
the Base ID (CH) selected in the left corner. This
display will not show if the system selected is
configured with login enabled (See Section 5.4 for
completing the login sequence.) After a delay, the
keypad will connect to the system. A sample image
is below.
Τ ρ υ ε
The number in the upper left of the display changes
to the keypads assigned address (ID) and the current
system question settings are applied.
indicator is actively showing signal strength.
view the Base ID at any time in the future, press the
BASE key.
Three other possible messages are possible instead of
a successful connection.
Ν ο τ
Α υ τ η ο ρ ι ζ ε δ
The
above
message
Authorization is enabled and the keypad serial
number is not amongst those in the list of keypads
allowed on the system. Either press the BASE key to
locate another system or see system administrator.
Β α σ ε Ν ο τ
Α χ χ ε π τ ι ν γ
>
>
Φ α λ σ ε
The RF
To
appears
when
system