DOD Dimension12 Panduan Pemilik - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Peralatan Perekaman DOD Dimension12. DOD Dimension12 12 halaman.

Dimension12

EFFECT

The effects parameter controls consist of an FX on/off button (17),

a mix knob (21), an effects LFO speed control (18), a modulation

depth control (19), and an effects feedback control (20). Effects

may be used in both record and play back mode. The effect on/off

is linked individually with each memory bank. Chorusing can be

acheived with depth set to 1:00, feedback set to 9:00, and speed

set to 8:00, and mix of 50% Flanging is acheived by setting depth

to 3:00, feedback to 12:00, and speed to 10:00. For effects oper-

ation in delay mode make sure delay time is set to 0.

RECORDING WITH EFFECTS

Press the FX button and adjust the controls (speed, depth, feed-

back, mix) to the desired effect. Note, the dry signal can be heard

out of the main channel while in record mode, and the wet/dry mix

out of the monitor channel.

The FX button can be pressed for, and is, independently linked to

each of the memory banks, however, the settings of the FX para-

meters (speed, depth, feedback and mix) are globally set with the

controls. Even if the sample was recorded with effects, the sam-

ple can be played back with effects, thereby increasing the modu-

lation effect.

FOOTSWITCH - The optional 3 button foot switch (FS3M) con-

trols the following functions: In sampling modes, switch 1 is stop,

and switch 3 is play. For the delay mode, switch 1 sample/hold,

switch 2 is tap tempo, and switch 3 is effect on/off. in reverse

mode only tap tempo is operational.