3M 603 Panduan Memulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Produk Pernapasan 3M 603. 3M 603 2 halaman.

Halaman Cetak

Step 4: Filter connection to facepiece

1. Align notch on edge of 603

adapter with facepiece

mark in order to properly

align filters.

Step 5: Donning respirator & adjusting fit

1. Place the respirator over

your mouth and nose

and nose and pull head

harness over the crown

of head.

Adjust the straps so the respirator is comfortable and snug, but do not overtighten.

Note: Decrease strap tension by pushing out on back side of buckles.

Note: Use of the EVF does not change donning steps.

Step 6: Positive Pressure User Seal Check

Place the palm of your hand over the exhalation valve cover (if using the EVF place

the palm of your hand over the EVF opening) and exhale gently. If facepiece bulges

slightly and no air leaks are detected between your face and the facepiece, a proper

seal has been obtained. If faceseal air leakage is detected, reposition respirator on

your face and/or readjust tension of the elastic straps to eliminate leakage. If you

cannot achieve a proper seal, DO NOT enter contaminated area.

If you have questions, consult your supervisor or call 3M Technical Service at 1-888-870-7416

(USA) or 1-800-267-4414 (Canada).

Notice: These respirators do not have the properties required of a surgical respirator, and so would not be appropriate for use in a surgical setting.

Medical Solutions Division

3M Health Care

2510 Conway Ave.

St. Paul, MN 55144 USA

2. Rotate filter assembly

¼ turn clockwise until it is

firmly seated. Repeat steps

1-2 for second filter.

2. Connect the bottom

straps at the back of the

neck.

Phone: 1-800-228-3957

Web: 3M.com/Medical

Facepiece with properly attached

filters shown.

Note: Rotate filters counterclock-

wise to remove.

3. Adjust top straps by pull-

ing on ends of straps.

other marks shown are marks and/or registered marks

of 3M. Unauthorized use prohibited.

GL_70-2011-7962-2

4. Adjust bottom straps by

pulling on ends of straps.