Dodge SLEEVOIL RTL 12 Petunjuk Manual - Halaman 4
Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Peralatan Industri Dodge SLEEVOIL RTL 12. Dodge SLEEVOIL RTL 12 12 halaman. Pillow blocks
Halaman Cetak
First, install the plate half without milled slots in the steel back.
Press the babbitted face against the thrust collar and rotate plate
around shaft into liner cavity.
Install retainer washer in groove in liner base. Rotate plate until
retainer washer.
stopped by
Place the other thrust plate half (half with two milled slots in steel
back) against thrust collar, making sure babbitt faces thrust
collar.
Clean and oil the second thrust plate set and install in same
manner. It may be necessary to move the shaft slightly to obtain
enough clearance in the liner cavity to install the lower plate half.
CAUTION: The bearing is not yet fastened in place and can
be moved.
Total axial clearance between thrust plates and thrust collar is
.015 - .030 inches.
INSTALLATION OF LINER CAP
Apply oil to the bearing area of liner cap.
WARNING: If it ever becomes necessary to remove liner cap,
make certain that both upper thrust plate halves remain in
place next to the thrust collar. If a plate half should remain
in the liner cap it can drop from the liner and cause injury.
CAREFULLY locate liner cap on liner base. These SLEEVOIL
liners have match-marks permanently stamped at the joint near
one end. These match marks permanently insure that parts
stay paired and critical orientation of assemblies is maintained.
Makes sure oil rings rotate freely. End faces of liner should have
no appreciable offset.
Install cap screws and tighten alternately to torque given in Table
2.
NOTE: If liner cap on non-expansion bearing will not drop into
place, remove cap and reposition thrust plates tightly against
thrust collar. Reinstall liner cap.
RTL
SLEEVOIL SIZE
3-7/16
3-15/16
4-7/16
4-15/16
5-7/16
6
7
8
9
10
12
4
Table 2
LINER CAP BOLTS
TORQUE
THREAD SIZE
(IN.-LBS.)
5/16 - 18
132
5/16 - 18
132
5/16 - 18
132
5/16 - 18
132
5/16 - 18
132
3/8 - 16
240
½ - 13
600
½ - 13
600
½ - 13
600
¾ - 10
2100
¾ - 10
2100