Dodge SLEEVOIL RTL 9 Petunjuk Manual - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Peralatan Industri Dodge SLEEVOIL RTL 9. Dodge SLEEVOIL RTL 9 12 halaman. Pillow blocks

Halaman Cetak

Tighten set screws to value specified in Table 1. Install and

tighten jam screws 1/10 of torque specified for set screws.

Oil shaft in the bearing area and CAREFULLY set shaft in place.

RTL

SLEEVOIL

CLAMP SCREW

SIZE

SCREW SIZE

(SOC. HEX)

3 7/16 RTL

¼ - 20NC

315/16 RTL

¼ - 20NC

4 7/16 RTL

¼ - 20NC

415/16 RTL

5/16 - 18NC

5 7/16 RTL

3/8 - 16NC

6 RTL

½ - 13NC

7 RTL

½ - 13NC

8 RTL

½ - 13NC

9 RTL

5/8 - 11NC

10 RTL

¾ - 10NC

12 RTL

¾ - 10NC

The thrust collar must be centered in the cavity of the liner base.

INSTALLATION OF OIL RINGS

NOTE: Do NOT use oil rings if liner cap has baffles installed

in the oil ring grooves.

Oil rings are shipped disassembled with two extra screws. Place

oil rings around outside of liner base and over shaft.

NOTE: Oil ring halves are match-marked and MUST NOT be

interchanged.

Table 1

THRUST COLLAR

SET SCREW

WRENCH

SCREW SIZE

WRENCH

TORQUE

(SOC.HEX)

TORQUE

(IN.-LBS.)

160

5/16 - 24NF

160

5/16 - 24NF

160

5/16 - 24NF

325

5/16 - 24NF

580

3/8 - 16NC

1425

3/8 - 16NC

1425

3/8 - 16NC

1425

5/8 - 11NC

1200

2800

5/8 - 11NC

1200

5000

5/8 - 11NC

1200

5000

5/8- 11NC

1200

Place oil ring around outside of liner base and over shaft.

Install oil ring screws to insure they are secure. Repeat for

second ring.

Make sure oil rings rotate freely on shaft.

INSTALLATION OF THRUST PLATES

For non-expansion bearings:

Clean one set of babbitt faced thrust plates.

NOTE: Thrust plates are shipped in protective wax with the

babbitted faces on the outside. Be careful not to damage

the babbitted faces when peeling off the wax.

NOTE: Plates are matched halves and MUST NOT be

160

interchanged.

160

275

Carefully smooth any scratches on babbitted face with crocus

cloth (NOT emery cloth or sandpaper). Oil plate halves generously.