DOEPEFER A-157-2 Manual - Halaman 3

Jelajahi secara online atau unduh pdf Manual untuk Peralatan Musik DOEPEFER A-157-2. DOEPEFER A-157-2 4 halaman. Trigger-sequenzer

DOEPFER

4. Setting up the A-157-2/3 modules

WARNING:

STRICTLY

Install carefully and gently. Doepfer cannot accept responsibility

or liability for modules damaged by installing them improperly or

by using brute force.

The A-157-1 main module needs to be mounted in your

eurorack case side by side the A-157-2 trigger output

module and the A-157-3 control input module. Simply

connect flat ribbon cables with the following sockets:

•

(1) the socket labelled „JP2" of the A-157-2 trigger output

module with the socket labelled „JP3" on the A-157-1

trigger matrix PCB.

•

(2) the socket labelled „JP1" of the A-157-3 control input

module with the socket labelled „JP4" on the A-157-1

trigger matrix PCB.

•

(3) the socket labelled „JP1" of the A-157-2 trigger output

module with the A-100 bus power connector.

•

(4) the socket labelled „JP1" of the A-157-1 trigger matrix

module with the A-100 bus power connector.

OBSERVE

THESE

INSTRUCTIONS!

System A-100

Please make sure that the position of the flat ribbon cables

coloured stripes fit to the figure on the following page resp.

to the labelling on the PCBs.

The figure on the following page will show you claerly all

necessary connections. Again – please strictly observe

these instructions!

Trigger-Sequenzer A-157-2/3