Etaluma Lumascope 500 Panduan Memulai - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Termostat Etaluma Lumascope 500. Etaluma Lumascope 500 12 halaman.

Halaman Cetak

LS500_400 Startup (date).pdf

LumaView500Install_v(version#).msi

2. Lumaview 500/400 cannot run on a computer with Lumaview 600-Series installed. If your computer

currently has Lumaview 600-Series installed, installation of Lumaview 500/400 may automatically

remove the 600-Series version and leave its drivers intact (which do not affect running of the 500/400

version). If you receive a message saying you cannot install Lumaview 500/400 due to another

Lumaview version being installed, uninstall the Lumaview 600-Series using the quick procedure

described in Appendix B.

3. After downloading Lumaview 500/400, install the program by double clicking on

Lumaview500Install_v(version#).msi. You will be asked about the location; note that the default is a

new or existing Etaluma folder inside the Program Files (x86) folder. During installation, a shortcut icon

named USB Driver Setup will appear on the computer desktop. After installation of the program, click

on the icon to open the USB Driver Installer. Follow the commands to download the Driver. After

installation, a Lumaview icon (orange circle named Lumaview 500-400) convenient for launching the

software will be present on the desktop.

F. Connecting the LS500

1. If connecting with a computer that has been off, turn computer

on. Make sure computer is connected to its monitor. Remove

the LS500 from its packaging. Insert the standard USB-A end of

the supplied USB power/communication cable into a USB port

on your computer and the other square USB-B end into the

square port (middle of the three ports) on the back of the LS500

(see Fig. 1). We highly recommend that you use the same USB

port on your computer every time you connect to the LS500. It

is also best to connect the LS500 directly to the computer USB

port rather than through a USB hub.

If Lumaview 500/400 has not been run previously, it is important that the USB cable be connected first

between the LS500 and computer. This is because Windows needs to load the USB driver before

Lumaview is launched. After the first time, the program can be launched without the USB cable

connected. However, only the Outer Main Window will open (see following section). Connect the USB

cable between the LS500 and computer and the Live Window will open.

2. Launch the Lumaview 500/400 software using the desktop icon and allow the LS500 to be discovered.

This may take a minute or so the first time. Two windows will open on your screen:

a. Live Image Window maximized inside the outer Main Window with upper navigation tabs File,

Windows, and Help. If the Live Image Window is changed to not maximized, it now shows the

name Lumascope and the upper navigation tabs File, Windows, and Help are now present on the

Main Window.

b. Outer Main Window with name Lumaview 500/400 v(version#) - Lumascope. If the Live Image

Window is changed to not maximized, the word Lumascope transfers to become the name of the

Live Image Window and the upper navigation tabs File, Windows, and Help are now present on the

Main Window.

Etaluma, Inc. | 3129 Tiger Run Court, Suite 112 | Carlsbad, CA 92010 | 760-298-2355 | www.etaluma.com

Lumascope 500/400 Startup Guide

This Startup Guide

Lumaview 500/400 software program

Fig. 1. Photo of Lumascope 500

back panel.