Doepke Dupline DRO 1U Panduan Petunjuk Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Unit Kontrol Doepke Dupline DRO 1U. Doepke Dupline DRO 1U 8 halaman. Shutter control unit

Doepke
ceive adjoining addresses. You should always start with an uneven address figure.
Example:
The preferred switching direction in the event of a bus fault ("UP" = 1 or "DOWN" = 0) can also
be preset with the hand encoder; the standard setting is „UP".

11. Putting into Service

Installation may only be carried out by an authorized technician. Observe the connection dia-
gram when installing. All leads to be connected must be dead.
The phase input serves to supply the unit as well as the actuating output.
In order to avoid malfunctions, the length of the line between push-button and the DRO 1U
should not exceed two meters.
The Dupline signal conductor (Dupline -) should be used as common potential, with the connec-
tion being made directly at the terminal. The following table illustrates the connection configu-
ration:
Terminal
C5
Semiconductor input C5
C6
Motor 2 output (DOWN/UP)
C7
Motor 3 output (UP/DOWN)
D-
Dupline signal conductor -
D+
Dupline signal conductor +
Connections between the Dupline signal and earth potential will cause malfunctions and are not
permissible. Attention should be paid to the correct polarity of the Dupline signal.
Because of the integrated power pack, the DRO 1U will warm up slightly after a short running
time. This is, however, no cause for concern.

12. Indicators

Indicator
Green "BUS OK"
LED

13. Guarantee

All professionally installed, unaltered devices are covered by warranty during the statutory guar-
antee period from the day of purchase by the end user. The guarantee is not applicable to dam-
age incurred during transport or caused by short-circuit or overloading. In the event of defects
in workmanship or material, which are discovered within the guarantee period, the company will
provide a replacement free of charge.
3931195/2009.02/H - The right to make technical changes reserved!
6
Description
Dupline bus:
Off - bus fault / On - bus OK
Wrong
UP
DOWN
G6
G7
P1
P6
Terminal
Brown
Switching channel „UP"
Brown
Switching channel „DOWN"
Black
Phase input (L
Blue
Neutral (N)
Description
Right
UP
DOWN
M3
M4
P1
P2
Description
)
IN