ClipperCreek CS EVSE Pedestal Panduan Instalasi - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Rak dan Dudukan ClipperCreek CS EVSE Pedestal. ClipperCreek CS EVSE Pedestal 20 halaman. Electric vehicle supply equipment
Halaman CetakCS EVSE PEDESTAL INSTALLATION GUIDE
INITIAL PEDESTAL INSTALLATION (continued)
ClipperCreek
, Inc.
3..Mounting.the.Pedestal.Post
Once the concrete pad with anchor bolts has been
prepared and the service conductors have been pulled
through the underground conduit, the pedestal post
may be placed.
•
Feed all service conductors up through the
inside of the pedestal post. The conductors
must be of sufficient length to pass beyond
the top of the pedestal so that final connections
can be worked with comfortably at a later step.
•
Align the pedestal post base notches with the
four anchor bolts and ease it into place.
•
Nuts and washers may be used under the
pedestal base to adjust the vertical alignment of
the pedestal should the concrete pad not be level.
•
Secure the pedestal post base to the concrete
anchor bolts using appropriately sized nuts and
washers.
•
The anchor bolts, nuts and washers used for
the installation of the pedestal base are
not included in the pedestal kit and must be
purchased separately.
Figure 6: Pedestal Post Mounting by Pattern
Wire Access Hole
Wire Access
Hole
Your
configurations.
may vary
slightly
from what is
depicted in
this.manual..
4..Install.the.Pedestal.Base.Cover
A two-piece pedestal base cover set is included in the
pedestal kit. The purpose of the pedestal base cover
is to beautify the installation and to protect against
injury from protruding anchor bolts.
•
The two covers are of an identical overlapping
design.
•
Slide one cover on the front side of the
pedestal base until the center notch surrounds
half of the pedestal post. Slide the other cover
onto the rear side in the same manner. Ensure
that the flanges of each cover piece are tucked
inside of the opposite cover.
•
Align the four screw holes of each cover piece
with the corresponding screw holes on
the opposite cover.
•
Secure each cover piece to the other with four
(4) #6-32 x 3/8" flat-head tapered screws using
a #2 Philips-head screwdriver.
Figure 7: The Pedestal Base Covers
5..Remove.the.Pedestal.Post.Cap
A pedestal cap is provided to cover the opening to
protect the conductors and inner pedestal from the
elements. It may have already been assembled on the
post for protection during shipping. Remove the Cap
from the top of the pedestal
Figure 8: Pedestal Post Cap Removal
Remove.the.Cap.and.screws/washers
Page 10