ClipperCreek CS EVSE Pedestal Panduan Instalasi - Halaman 17
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Rak dan Dudukan ClipperCreek CS EVSE Pedestal. ClipperCreek CS EVSE Pedestal 20 halaman. Electric vehicle supply equipment
Halaman CetakFINAL PEDESTAL INSTALLATION
14..Wiring.the.Conductors.to.the.EVSE
The three service conductors must be wired to the
EVSE internal chassis and contactor.
•
Strip the end of the ground conductor and
insert the exposed wire into the Service
Ground Terminal Block.
•
Tighten the Service Ground Terminal screw
using an appropriately sized flathead
screwdriver.
•
Strip the ends of the two live conductors.
Insert the exposed wire of the first live
conductor into the "2T1" terminal on the
bottom of the contactor.
•
Insert the exposed wire of the second live
conductor into the "4T2" terminal on
the bottom of the contactor.
•
Tighten the contactor terminal blocks using 1/4"
flathead screwdriver or 5/32" hex head wrench.
Figure.18:.Wire.Service.Conductors.to.the.Chassis.
15..Install.the.CS.Series.Connector.Holster(s)
•
Attach the Connector Holster Assembly to
the CS Unit using the four machine screw
fasteners provided with the Holster
assembly. The Holster will attach to the CS
unit on the lower right hand corner of the
enclosure, just below the door latch. Use a #2
Phillips screwdriver for installation.
(If using a powered screwdriver, set it to a
.
.
low.torque.value.)
•
Place connector into the holster for storage.
INSTALLATION OF THE CS EVSE IS NOW COMPLETE. PLEASE REFER TO THE CS USER MANUAL
FOR TROUBLE-SHOOTING AND ADDITIONAL INFORMATION.
CS EVSE PEDESTAL INSTALLATION GUIDE
Figure.19:.Install the CS Series Connector Holster(s)
16..Complete.the.Installation
•
Close the EVSE door and lock the safety
latch. Replace the two door screws on the left
side of the EVSE enclosure and tighten them
using a T15 Torx driver. Do not overtighten.
•
Verify the safety of the installation prior to
turning on the circuit breaker.
•
Refer to the CS EVSE User Manual for further
operational and maintenance information.
•
Mount the cable saddle that is included
with the CS EVSE at this time if it was not
previously installed.
17..Wrap.and.Stow.the.Vehicle.Connector(s)
•
Loosely wrap the cable counter clockwise
around the CS EVSE cradle as shown in
Figure 20.
•
Verify the safety of the installation prior to
turning on the circuit breaker.
•
Refer to the Charging Station User Guide for
further operational and maintenance
information.
Figure 20: Loosely Wrap Cable Counter Clockwise
around the the Cradle
Cradle
ClipperCreek
, Inc.