Doepke Dupline Panduan Petunjuk Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Sistem I/O Doepke Dupline. Doepke Dupline 8 halaman. Dss 4ur-n/-p 4-way input/output modules

Halaman Cetak
Doepke
ther a supply voltage nor the Dupline signal and is carried out with the aid of the DKP 2 flat-
plug coding cable. Attention should be paid to the correct polarity of the coding cable; incorrect
polarity will not, however, cause permanent damage.
Although the coding is permanently retained, it may always be overwritten.

10. Putting into Service

Observe the connection diagram when installing. All lines to be connected must be dead. Con-
nections between the Dupline signal and earth potential will cause malfunctions and are not
permissible. In addition, check for the correct polarity of the Dupline signal.
The following table illustrates the further connection configuration:
Cable Loom S1
Cable Loom S2
Cable Loom S3
The connection diagram is shown in Chapter 13 on page 8.

11. Guarantee

All professionally installed, unaltered devices are covered by warranty during the statutory gu-
arantee period from the day of purchase by the end user. The guarantee is not applicable to
damage incurred during transport or caused by short-circuit, overloading or improper use. In
the event of defects in workmanship or material, which are discovered within the guarantee pe-
riod, the company will provide a repair or replacement free of charge. The guarantee will be
rendered null and void if the device is opened without authorization.

12. Technical Data

Dupline
Input channels
Output channels
Inputs
3931305/2014.15/E - The right to make technical changes reserved!
6
Pin
Color
1
yellow
2
green
3
brown
4
brown
1
green-black
2
yellow-black
3
blue-black
4
grey
5
red
6
blue
7
yellow
8
green
Current input
Type
Operating voltage +24 V DC
Operating voltage +24 V DC
Operating voltage 0 V DC
Operating voltage 0 V DC
Input signal signal 1 (I1)
Input signal signal 2 (I2)
Input signal signal 3 (I3)
Input signal signal 4 (I4)
Output signal 1 (O1)
Output signal 2 (O2)
Output signal 3 (O3)
Output signal 4 (O4)
Min.
Typ.
750 µA
Bus signal decoupled semi-conductor inputs
Signal
Max.
4
4