Doerr SnapShot Mobil Black 5.1 Buku Petunjuk - Halaman 4

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Kamera IP Doerr SnapShot Mobil Black 5.1. Doerr SnapShot Mobil Black 5.1 6 halaman.

Halaman Cetak

SnapShot Extra / Extra black

SnapShot Mobil / Mobil black 5.1

Instruction Manual

Enter mobile phone number

without country code

Enter email address

DÖRR SNAPSHOT MOBIL 5.1 SMS Function

The camera can be controlled by SMS commands from a mobile phone. For example you can switch the camera from photo to video mode, request a real-time

image or the location, change phone numbers and email addresses in the recipients list.

Turn on the SMS function

To use this feature, please select "ON" for "SMS switch"

in the Operator parameters.

List of SMS commands

ACTION

SMS COMMAND

Add telephone number

#140#1#telephonenumber#

Delete telephone number

#140#0#telephonenumber#

Add Email address

#141#1#Email address#

Delete Email address

#141#0#Email address#

Photo Modus

#310#P#

Video Modus

#310#V#

Request real-time image

#500#

Request location

#510#

Picture transmission On

#200#On#

Picture transmission Off

#200#Off#

NOTES:

Request real-time image

With SMS #500# the camera takes a real-time image and sends it immediately to the stored receivers according to the settings. This process can take a few minutes.

If set to GPRS transmission, picture will be sent to your email address.

Request location

With SMS #510# the longitude and latitude degrees is reported, based on where the camera is located at the moment of the shot. The data is based and transmitted via the

network operator and are therefore may not be very accurate. A text message with location of camera will be sent to the mobile phone number which has sent the request.

Picture transmission On/Off

With SMS #200#Off# the image transmission is turned off. During this time pictures are stored on SD card, but not transmitted via MMS or GPRS. By sending command

#200#ON# the transmission will be continued.

If you sent a wrong SMS command, you will receive a text message showing „command is invalid". During picture transmission or while executing other commands,

you will receive text message showing „command is busy. "

DÖRR GmbH • Postfach 1280 • 89202 Neu-Ulm/Germany • Fon +49 731 97037-0 • Fax +49 731 97037-37 • [email protected]

Recipients

Here you can specify the recipient telephone number and email addresses.

You can enter up to 4 phone numbers and email addresses.

Note: The more receivers are added, the longer takes the transmission! Please separate the individual

numbers and addresses with a semicolon „;".

Enter your mobile phone number without country code, e.g. 0160 1234567. At least one number has to be set.

Rename and Max Size

It is possible to enter a name for the camera. Under Rename a name can be entered using up to 8 characters.

The name appears on each image.

Before sending, the image files will be scaled down due to the transfer speed. The image size can be selected

from 60 KB to 120 KB.

The command number is „Phone number 1". This number has the right to change saved

phone numbers (numbers 2, 3, and 4) and email addresses. All stored numbers can execute

the commands according to the following list, in order to control the camera.

An answer whether changes were made or message about camera location (if requested) will

be always sent to the mobile phone number, which requested it.

CAMERA FEEDBACK VIA SMS

(Number) added

(Number) deleted

(Email address) added

(Email address) deleted

The current mode is photo

The current mode is video

Real-time picture via GPRS or MMS

Location via text message

GSM is waked up

GSM enters sleeping mode