Dog Care NONO RE Manual - Halaman 2

Jelajahi secara online atau unduh pdf Manual untuk Produk Perawatan Hewan Peliharaan Dog Care NONO RE. Dog Care NONO RE 5 halaman. Bark control collar

Halaman Cetak

6. Charging

a. The NONO RE(Model AB02) uses a micro USB cable and a rechargeable DC 5V battery.

b. It typically takes about 2 hours for the unit to fully charge. (Note: charging the battery

overnight or for too long can diminish the overall life of the battery).

7. Bark Control Modes

a. The bark control collar has two modes. Vibration and Static.

b. To choose the desired mode press the Mode button on the top of the collar. For

vibration mode the LED light will flash blue. For the static mode the LED light will flash

red.

c. When there is no barking the collar will automatically enter the standby mode and the

light will flash either blue or red every 25 seconds depending on which mode has been

chosen.

8. Barking Sensitivity Levels

a. There are 5 levels of sensitivity, suitable for dogs with different barking volumes.

b. The sensitivity level can be adjusted by pressing the sensitivity button on the top of the

collar.

c. Level 1 is the lowest sensitivity, meaning only a loud bark will activate the device. Level

5 is the highest sensitivity where a quieter bark can activate the device. (The light bar is

fully lit at level 5 – the highest sensitivity).

d. Adjust the sensitivity according to the volume of your dog's barking to make sure the

bark control collar will work properly.

e. The collar must be withing 15cm of the dog's mouth, and the sound sensor will only

activate when it detects the sound level corresponding to the current sensitivity range.

9. Testing the collar

a. Important: To avoid feeling the Static Correction yourself, never touch the two contact

points simultaneously.

b. Turn on the bark control collar and switch to vibration mode.

c. Hold the collar with the sound activated sensor facing you and within 5 to 10 inches of

your mouth.

d. In order to trigger the unit, blow into the sensor. The unit should vibrate and beep, and

the blue light will flash.

e. If the unit does not work properly, please make sure the battery is installed correctly

and/or replace the battery.

10. How It Works