Dog trace d-control 300 Panduan Pengguna - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Produk Perawatan Hewan Peliharaan Dog trace d-control 300. Dog trace d-control 300 15 halaman. Aqua spray
Halaman Cetak
Switching off:
1. Place the lower part of the transmitter near the red target on the receiver - indicator
light will shine red, then orange.
2. Once the light is orange remove the transmitter from the receiver - the light will
shine red.
Important: When turning on, simply put the bottom of the transmitter on the
receiver's target for approx. 1 second. If you hold the transmitter at the receiver
target for more than 5 seconds, the receiver enters pairing mode. This mode is
indicated by alternating flashes of green and red indicator light. If this happens,
follow the chapter below - Pairing the transmitter and receiver.
Pairing the receiver with the transmitter
Each transmitter has its own radio code. For the transmitter to communicate with
the receiver, they must be paired together. If you have purchased a new d-control
transmitter/receiver set, no pairing is necessary – the set is already paired. Pairing is
only done if you want to use another transmitter or receiver.
The transmitter is designed for training two dogs, so you may pair it with two receivers.
Use buttons 1 and 2 to select one dog or the other.
Important: Before pairing the transmitter and receiver, make sure that no one else
in your vicinity is using their own d-control. Your receiver could receive the code
of another transmitter. If this happens, re-pair your receiver with your transmitter.
Pairing procedure
1. Turn on the transmitter.
2. The receiver must be off.
3. On the transmitter, select the position (button 1 / 2), you want to pair with.
4. Place the lower part of the transmitter to the red target on the receiver and hold for
5 seconds. The LED indicator of the receiver will shine red, then orange.
5. After 5 seconds the orange indicator light will flash 3 times.
6. Remove the transmitter from the receiver - alternating green and red lights will flash.
7. Press the acoustic signal button
by a long beep of the receiver.
Re-pairing the receiver
The number of times you may re-pair the receiver is unlimited, either with the same or
a different transmitter (see Pairing the receiver with the transmitter).
TIP: An unlimited number of receiver can be paired with one transmitter.
Example: On button 1 we pair 3 receivers, which can be paired one after another or
by putting all receivers in pairing mode and then pressing the acoustic signal button.
All of these receivers will respond the same when you press the command button.
For example, it's possible to use two training collars on one dog. Or alternatively for
training multiple dogs, where the same command is issue to all of them at once.
10
on the transmitter. Successful pairing is indicated