Dog trace d-balls Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk GPS Dog trace d-balls. Dog trace d-balls 11 halaman. Electronic ball dropper

Turning on: Place the lower part of the remote

controller to the marked arrow (see the picture).

The ball dropper indicator blinks in red (The ball

dropper is recognised). Remove the remote

controller when the LED diode lights up in red

permanently. The diode starts blinking in green

indicating the ball dropper is ready for use.

Turning off: Place the lower part of the remote

controller to the marked arrow (see the picture)

again. The receiver indicator lights up in red.

Remove the remote controller. The red LED

diode goes out. The ball dropper is turned off.

To prolong the battery lifetime, the ball dropper is

always to be turned off after training. If the ball

dropper is not used for a longer period of time,

removing batteries is recommended.

PROGRAMMING (PAIRING) OF THE REMOTE

Every remote controller has its own RF operational code. Programming of the remote

controller with the ball dropper will be performed during the first use of the Dogtrace

d-balls set or with a new remote controller or ball dropper (in case they get lost). This

operation enables you to match your remote controller with the delivered ball dropper.

IMPORTANT: Before programming (pairing) is started, make sure no one else is using

d-balls ball dropper or another Dogtrace product close to you. Your ball dropper could

randomly receive a code from another remote controller and set itself to it. If this happens,

program your ball dropper once again using your remote controller.

If you have inserted balls into the container, replace them.

Place the lower part of the switched-off remote controller to the arrow marked on the ball

dropper (see the picture on page 7). The red LED diode blinks, the green LED diode lights

up for 3 seconds. Then the red as well as the greed LED diode starts blinking. The ball

dropper is ready for pairing. Now move the remote control away and press the sound

button 1 to 4 on the remote control keypad to control the ball dropper. The ball dropper

should beep when the sound button is pressed.

Use the same procedure for pairing more ball droppers.

TURNING ON / OFF

CONTROLLER AND THE RECEIVER

Position when switching on/off the ball

dropper and when pairing the transmitter

with the ball dropper