Dogtra 2700T&B Panduan Pemilik - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Produk Perawatan Hewan Peliharaan Dogtra 2700T&B. Dogtra 2700T&B 19 halaman. 1-dog system only training & beeper collar

Halaman Cetak

10. Charging the Battery

1. Charge the unit before using the unit for the first time.

2. Do not charge the batteries near any flammable

substances.

3. Fully charge the batteries if the unit is to be stored

without use for a period of 3 months or more.

Recharge the Unit If:

• The LED indicator light on the receiver/collar is

emitting a red color.

• If the 3 bar indicator on the transmitter LCD shows

just 1 bar.

• The indicator light on the transmitter or receiver will

not come on.

• The indicator light on the transmitter or receiver

comes on momentarily, but will not stay on when the

Constant button is pushed.

Battery Charging Procedure

Charging Cable

The 2700T&B uses lithium-polymer batteries.

The battery charger and charging cables allow you to

charge both the transmitter and receiver at the same

time. The battery charger is designed for a 120 volt wall

outlet.

Note 1: Only use Dogtra-approved lithium polymer

batteries and chargers for your Dogtra e-collar. This

will prevent any damage that can be incurred from

attempting to use a different charger.

Note 2: The unit has a partial charge when it leaves the

Dogtra facility. Upon receipt of the collar, be sure to give

it a full 2-hour initial charge before the first use. When a

charger is not in use, disconnect it from the power source.

1. Attach the charging cables to both the transmitter

and receiver, as shown above.

2. Plug the charger into a 120 volt wall outlet or, if using

120 Volt

Charger

Wall Outlet