Dogtra 200C Panduan Pemilik - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Peralatan Kebugaran Dogtra 200C. Dogtra 200C 14 halaman.
Juga untuk Dogtra 200C: Manual Pengaturan Kode (2 halaman)

Halaman Cetak

Battery Charging Procedure

Charging Cable

The 200C uses lithium-polymer batteries.

The battery charger and charging cables allow you to

charge both the transmitter and receiver at the same time.

The battery charger is designed for a 120 volt wall outlet.

Note 1: Only use Dogtra-approved lithium polymer

batteries and chargers for your Dogtra e-collar. This will

prevent any damage that can be incurred from attempting

to use a different charger.

Note 2: The unit has a partial charge when it leaves the

Dogtra facility. Upon receipt of the collar, be sure to give

it a full 2-hour initial charge before the first use. When a

charger is not in use, disconnect it from the power source.

120 Volt

Charger

Wall Outlet

1. Attach the charging cables to both the transmitter and

receiver, as shown on page 18.

2. Plug the charger into a 120 volt wall outlet or, if using

the auto charger, plug into a cigarette lighter only for

lithium polymer batteries (use a 230 volt European

charger for Europe). All indicator lights should glow red

when properly plugged in and the unit will automatically

shut off during the charging process. You will need to

turn the unit on again before use once the unit is fully

charged and unplugged from the battery cable.

3. The lithium polymer battery is fully charged within

2 hours. The lights will stay red during the charging

process. The red light will turn green once the unit is

fully charged.

4. After charging, cover the battery charging receptacles

with the rubber plugs on the transmitter and receiver.