Akrobat ORBIT Instalasi dan Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Instalasi dan Panduan Pengguna untuk Olahraga & Luar Ruangan Akrobat ORBIT. Akrobat ORBIT 8 halaman. Rectangular

Halaman Cetak

Fitting the mat and installing the springs

Lay the mat flat inside the frame. Make sure the logo is facing upwards. In order to make the

installation of the jumping mat easier, locate the four rings in the corners of the jumping mat

and attach four springs on these locations first. Pass the springs through the spring loops on the

corners underside of the jumping mat. Then continue by attaching springs from the corners to

the middle of the mat until all springs are attached.

At first, it may look like the mat won't fit, it will

however stretch to the correct size when you

finish attaching all springs.

Important:

Be sure all spring hooks are well

attached to the frame.

AKROBAT HINT:

Springs can be hard to attach, you will need a little force. Help yourself by using one spring to pull

another towards the frame holes. Do not forget to wear gloves!

INSTALLATION AND USER MANUAL - ORBIT - RECTANGULAR

Important:

Be sure that you hook the corner spring trough

the loop in the corner. It will keep the corners

of the mat in place.

Attaching the frame pad

Lay the safety pad on the top of the trampoline with the eyelets facing up. Insert the elastic toggles

through the eyelets so the loop end of the elastic faces outwards and the toggle end is on the inside.

Flip the frame pad over and pull the elastic

band around the frame. Insert the toggle into

the loop, then rotate the toggle inwards to

secure it. Repeat with all frame pad elastics.

Important:

The frame pad must cover the

entire frame and all springs.

Secure the frame pad to the trampoline by

placing springs into the "spring loops". You

will find them on the underside of the frame

pad where each pad section joins the next

one. Remove a single spring under every

loop, slip it through the loop and reattach

to the frame. Repeat with all loops. This will

prevent the front of the pads from lifting up.