Cymbol G3 Series Panduan Cepat - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Cepat untuk Kamera Keamanan Cymbol G3 Series. Cymbol G3 Series 13 halaman. Network transmitter
Juga untuk Cymbol G3 Series: Panduan Cepat (13 halaman), Panduan Cepat (16 halaman), Panduan Cepat (12 halaman)
Halaman Cetak•
Connecting to the RJ-45
Connect a standard RJ-45 cable to the network port of the network camera. Generally a
cross-over cable is used for directly connection to PC, while a direct cable is used for connection
to a hub.
•
Connecting Alarms
AI(Alarm In) :
You can use external devices to signal the network camera to react on events. Mechanical or
electrical switches can be wired to the AI (Alarm In) and G (Ground) connectors.
G(Ground) :
Connect the ground side of the alarm input and/or alarm output to the G (Ground) connector.
AO(Alarm Out) :
The network camera can activate external devices such as buzzers or lights. Connect the device
to the AO (Alarm Out) and G (Ground) connectors.
•
Connecting the Power
Connect the power of DC12V or AC24V 450mA for the network camera. Connect the positive(+)
pole to the '+' position and the negative(-) pole to the '-' position for the DC power.
•
LED Indicators
LED
Color
Green
Network
Amber
Unlit
Status
Red
Power
Green
Note: Steady green and red during booting. Flash green and red during factory default.
•
Connecting Service Monitor Port
The Service Monitor output port is located rear the box camera and is used for easy OSD setup.
Steady for connection to a 100 Mbit/s network. Flashes for
network activity.
Steady for connection to 10 Mbit/s network. Flashes for
network activity.
No network connection.
Steady red for failed upgrade or booting.
Steady green for normal operation or booting.
Flashes green during firmware upgrade.
4
Quick Installation Guide
Indication