Aseptiscope DiskCover System Petunjuk Penggunaan Manual - Halaman 9
Jelajahi secara online atau unduh pdf Petunjuk Penggunaan Manual untuk Peralatan Medis Aseptiscope DiskCover System. Aseptiscope DiskCover System 16 halaman.
Halaman CetakInstall/Replace Batteries
1. Open battery door
2. If replacing batteries, remove
depleted batteries and dispose
appropriately.
3. Insert three (3) C batteries as shown
on the inside battery door, placing
center battery in last (Figure 13).
4. Close battery door. If properly
installed, the batteries indicator light
will briefly appear green. Dispenser
will be ready for activation after 3
seconds (Figure 14).
Dispenser Replacement
1. Remove Clean Cassette and batteries.
2.
While holding the sides of the dispenser,
locate the release tabs near the top of
the wall mount (figure 15) and press
towards the center (Figure 16).
3. While depressing the tabs, raise the
dispenser until clear of the wall mount
(Figure 17).
4. If replacing the dispenser,
see Dispenser Installation section.
Figure 13
Figure 14
Figure 15
Figure 16
Figure 17
9