Dohle ExOn3A-5 Panduan Petunjuk Pengoperasian - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Sistem Pengelasan Dohle ExOn3A-5. Dohle ExOn3A-5 14 halaman.

Operating Instructions

DOHLE Hand Welding Extruder ExOn3A

3. Start-up

General:

Observe the notes on safety contained in these operating instructions. In addition, the

regulations on the prevention of accidents and the national regulations shall apply.

Assembling the hand-held welding and extruding machine

Our hand extruders are largely fully assembled ready for accommodated.

Weld shoe

The machine is supplied with one weld shoe blank which can be machined to suit your

requirements.

Note: please observe guideline DVS 2207 part 4.

If you indicate your required form of seam and thickness of plates we will supply one weld

shoe machined ready for use.

Start-up of hand-held welding extruder

Observe the Safety chapter of this manual.

Before plugging in the power cord, please check that

- The heating is switched off at the air heater

- The engine is not set for continuous adjustment

- Plug in the power cord

Enter the power cord into an AC outlet (230V, 16A), use only easily accessible electrical

outlets, you represent now the on - off

the heater switch on the ON position.

The machine heats now on to the last selected setpoint temperature.

To change the temperature, they change the setting of

Potentiometer on the heat gun.

The hand extruders exon 3A has a bi-metal cold start protection, the

Device only partially protects against major damage. Always observe the longer

Heat-up times and minimum temperatures of the materials to be processed.

Incorrect operation has a fraction of the screw or the transmission of

Follow.

Warranty claims that are due to incorrect operation cannot be claimed

Caution: Observe minimal heat time of 20min.

Let the appliance unattended while it is operating.

DOHLE Extrusionstechnik GmbH